Abstract:The cavitation damage in the Engine cooling water pump (ECWP) is the key factor that shortens the lifespan of automobile cooling systems, and causes vibration and noise. To improve cavitation performance and external characteristics of ECWP, three optimized models were designed on the basis of WP7 diesel ECWP. The whole flow fields in three models and the prototype pump were numerically simulated, employing the time averaged Navier-Stokes equation, the standard k-ε turbulent model and Zwart-Gerber-Belamri multiphase flow model by ANSYS-CFX software. Pressure distribution, turbulent kinetic energy distribution, bubble volume fraction distribution, external characteristics and cavitation performance of the prototype pump and optimized models were compared and analyzed. The results show that the external characteristics and cavitation performance of the optimized models are significantly better than that in the prototype pump. Through decreasing the inlet blade angle and wrap angle, extending the blade to inlets and extending a certain inclination in the blade, shock loss in blade inlet was reduced and so, the performance of pump will be improved. The flow condition at blade inlet will also be improved greatly, which in turn improves cavitation performance. When reducing the quantity of blades, the excretion coefficient will drop, flow area of blade inlet becomes bigger, but head has a little drop. And the pump optimized by reducing the quantity of blades has the optimal cavitation performance among three optimized models. With the decrease of impeller diameter, the absolute pressure in the critical cavitation point becomes bigger, the inlet bubble volume fraction at the same absolute pressure increases while cavitation performance gets worse. The obtained numerical results were compared with the experimental ones, and the outcome showed the same tendency between the two along with acceptable error.

Optimized Design of Steam Jet Pump

Multi-Objective Optimization of Multistage Centrifugal Pump Based on Surrogate Model

Hydraulic Optimization of Super-low Specific Speed Multistage Flameproof Submersible Pump with Inner Motor for Coal Mine

The Optimization of A Low Specific Speed Pipeline Pump

Design Method of Water Jet Pump Towards High Cavitation Performances

Research on hydraulic optimization design method of water-jet propulsion pump considering hump index

Multi-Point Optimization on the Diffuser of an Axial Flow Pump

Research on Energy-saving Optimization of Parallel Pumping System

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Analysis and Optimization on U-shaped Damping Groove for Flow Ripple Reduction of Fixed Displacement Axial-Piston Pump

Optimization of Cross Angle Based on the Pumping Dynamics Model

Numerical calculation and optimization designs in engine cooling water pump

A New Design Method for the Transition Region of the Valve Plate for an Axial Piston Pump

An Intelligent CFD-Based Optimization System for Fluid Machinery: Automotive Electronic Pump Case Application

Design Optimization Of A Mixed Flow Waterjet Pump For Performance Improvement Involving Cavitation

Automatic optimization of centrifugal pump based on adaptive single-objective algorithm and computational fluid dynamics

Optimum Design of Pump-Turbine for Bidirectional Flow Control

Investigation on Optimization Design of High-Thrust-Efficiency Pump Jet Based on Orthogonal Method

Optimization Research Of Parallel Pump System For Improving Energy Efficiency

Strategies employed in the design and optimization of pump as turbine runner

Hydraulic performance prediction and optimization of an engine cooling water pump using computational fluid dynamic analysis