Abstract:Airplanes stay lifted into the air due to the pressure difference exerted on their wings. Wings of aircraft are designed to generate lift by directing airflow such that it accelerates over the top and presses down more intensely on the underside. Although there exists a substantial body of literature that delves into the significance of airfoil design for improving aerodynamic efficiency, there is a conspicuous dearth of research pertaining to the development of a new airfoil derived from the NACA 23012 aerofoil. To bridge this critical gap in the current body of knowledge, this investigation aims to introduce innovation by crafting an original airfoil, building upon the foundational principles of the NACA 23012 aerofoil. The high-fidelity panel method was used to investigate an operating range of high Reynolds number, Re = 2 × 10 6 . Many reconfigured airfoils have been designed and analyzed using a parametric study in XFLR5. The numerical setup's validity is established through a comparative analysis with Miley's experimental findings, revealing that the setup exhibits errors of less than 4% across all tested cases. Additionally, in a panel dependency test, the setup demonstrates minimal variation, with discrepancies remaining under 1%. To improve the aerodynamic performance of the new airfoils, geometrical parameters, such as, the leading-edge radius, trailing-edge radius, maximum thickness, and maximum chamber of the NACA 23012 were modified. After analyzing multiple cases, the optimum results for each geometric parameter are combined to generate three new airfoils. The final airfoil with the highest lift-to-drag ratio is further analyzed using flaps. The results show that the new airfoil exhibits a 7% higher lift, 5.2% higher sliding ratio than the base foil, and a 46% lower coefficient of moment than the base foil. An analysis performed on a 3D wing constructed with the new airfoil shows its applicability in constructing a light aircraft. This study contributes to providing a proper overview of effective airfoil design and outlines the necessary short procedures.

Design of airfoil with high ratio of lift over drag

Sensitivity-Based Parameterization for Aerodynamic Shape Global Optimization

Particle Swarm Optimization of Aerodynamic Shapes with Nonuniform Shape Parameter–Based Radial Basis Function

Optimization Design for Supersonic Inlet Structure Parameter

Aerodynamic Design Optimization by Using a Continuous Adjoint Method

Aerothermodynamic Shape Optimization of a Hypersonic Lifting Body

Airfoil Parameterization Evaluation Based on a Modified PARASEC Method for a H-Darrious Rotor

Multi-objective robust airfoil optimization based on non-uniform rational B-spline (NURBS) representation

Integral Airfoil Generation of Multi-rotor Aircraft Based on Optimization of Upper Wing Contour and CFD Simulation

An Inverse Design Method for Airfoils Based on Pressure Gradient Distribution

Airfoil Design Framework for Optimized Boundary-Layer Integral Parameters

Supercritical natural laminar flow airfoil optimization for regional aircraft wing design

Airfoil Optimization Using a Machine Learning-Based Optimization Algorithm

A Fast Multiobjective Optimization Approach to S-duct Scoop Inlets Design with Both Inflow and Outflow

A Study of Multi-Objective Aerodynamic Optimization Design for Variable Camber Airfoils and High Lift Devices

Optimization and Analysis of a Blown Flap Based on a Multielement Airfoil

Study on Airfoils and Aerodynamics of High-Speed Aircraft Propeller

Natural Laminar Flow Airfoil Design via Adjoint-Based Transition Onset Delay

Optimizing NACA Airfoil Thickness Function Parameters for Maximum Lift-to-Drag Ratio

Design of a Novel Aerofoil of a Light Aircraft for Robust Aerodynamic Performance at High Reynolds Number Regime Using XFLR5

A new method based on the dynamic evolution of airfoil