Abstract:The nanocrystalline TiO2 film electrodes were prepared by sol-gel method at different calcining temperatures, which had characteristics of different film thickness, uniform transparency, as well as high photoelectric and mechanical stability. Photoelectric measurements show that calcining temperature and film thickness could remarkably influence the photoelectric properties of the electrodes. The film calcined at 450°C is anatase phase with high crystallinity and strong photoelectric activity, and shows the largest photocurrent. When the temperature is lower than 450°C, the film has weaker crystallinity because of a large number of defects in the film, and this is not favorable for the transport of the photogenerated carriers. And at a temperature higher than 450°C, the photocurrent of the electrode is decreased due to anatase-rutile phase transition in the film. The increase in film thickness is favorable to the enhancement of ultraviolet light (UV) absorption amount, which would improve the photoelectric activity of the film. But, excessive thickness will increase the recombination rate of the electron-hole pairs, and result in a reduction in electrode’s photoelectric activity. In addition, the response sensitivity and stability of the photocurrent produced in the electrode are related to bias potential. At a potential of 0.4 V, the electrode shows a saturated photocurrent of 30.8 μA and a response time of ∼1 s, suggesting that the prepared TiO2 film electrode can be used for making UV sensors.

Electrochemical Studies On The Hydrophilic Mechanism Of Tio2 Thin Films Under Uv Irradiation

Photo-induced Hydrophilicity and Cyclic Voltammetric Behavior of TiO2 Thin Film under Ultraviolet Illumination with Different Wavelengths

Photoelectrochemical Characteristics of Nano-Titanium Dioxide Thin Films Prepared by RF Magnetron Sputtering

Controllable hydrothermal synthesis, optical and photocatalytic properties of TiO 2 nanostructures

Fabrication of Well-Aligned Tio2 Nanotube Arrays with Outstanding Light-Induced Hydrophilicity Performance

Two Photoelectrochemical Processes for TiO2 Electrode under UV Illumination

Temperature-dependent differences in wettability and photocatalysis of TiO 2 nanotube arrays thin films

Influence of Iron Dopant on Crystallization and Photo-Induced Hydrophilicity of TiO2 Thin Films

Cyclic voltammetric and Ac impedance behavior of TiO2 electrodes under UV illumination

The Preparation of Transient Nanocrystalline TiO2 Film and the Study on It's UV Photoelectric Property

Study on Structural, Optical and Hydrophilic Properties of FTO/TiO2 Tandem Thin Film Prepared by Aerosol-Assisted Chemical Vapor Deposition Method

Study of Self-Cleaning and Low-Emission Properties of FTO/TiO2 Composite films

Oxidation Conditions of Ti and Photocatalysis of TiO2 Ceramic Films

Hydrophilicity and Photocatalysis of Ti1−xVxO2 Films Prepared by Sol–gel Method

TiO2 films prepared by DC reactive magnetron sputtering at room temperature: Phase control and photocatalytic properties

The Mechanism of Hydrophilic Surface of TiO2 Thin Films Induced by Heat and Light

The Research On Hydrophilic Properties Of Tio2 Thin Film Prepared By Dc Magnetron Sputtering

Photoelectrochemical properties of TiO2 thin film electrodes under visible light illumination

Studies of Photo-induced Characteristics of Nanoscale Titanium Dioxide Thin Films Grown by RF Magnetron Sputtering

Effects of Electron Transfer between TiO<sub>2</sub>Films and Conducting Substrates on the Photocatalytic Oxidation of Organic Pollutants

Preparation of Transparent TiO2 Nanocrystalline Film for UV Sensor