Abstract:An amphiphilic random copolypeptide, poly (gamma-benzyl-L-glutamate-co-N-(2-hydroxyethyl)-Lglutamine] (PBHG), was modified from hydrophobic poly(gamma-benzyl-L-glutamate) (PBLG) to improve hydrophilicity and applied to electrospin into ultrafine fibers. The molecular structure was confirmed by Fourier transform infrared spectroscopy (FTIR) and proton nuclear magnetic resonance spectroscopy (H-1-NMR). The effects of solvent type and PBHG concentration on the properties of spinning solutions were investigated by measuring surface tension, viscosity and conductivity of the solutions. The morphologies of electrospun fibers were observed by scanning electron microscope. The hydrophilicity and cell proliferation ability of PBHG electrospun fibrous mats were also evaluated by water immersion and MTT assay, respectively. It was found that PBHG takes rigid a-helix conformation and tends to self-orientate in trichloromethane (TCM) and tetrahydrofuran (THF) from which micron or submicron fibers could be electrospun. The fibers electrospun from PBHG/TCM solutions have poor quality due to large surface tension, high viscosity and low conductivity of the solutions, whereas those obtained from PBHG/THF solutions have smooth surface and homogeneous diameter. In trifluoroacetic acid (TFA), PBHG molecules take random coil conformation and physically entangle with each other. The low surface tension, low viscosity and high conductivity of PBHG/TFA solutions are beneficial for electrispinning nano-fibers, but the low volatility of TFA leads to fiber adhesion. It can be alleviated by using TFA/TCM binary mixtures with suitable TFA content as solvent. PBHG electrospun fibers proved to be more hydrophilic than that of PBLG, and could maintain the skeleton in the water without further crosslinking. MTT results confirmed that PBHG fibers are non-cytotoxic and can promote the cell proliferation.

Biodegradable Polymeric Ultrafine Fibers by Electrostatic Spinning

Preparation of nonwoven mats of poly(L-lactic acid)nanofiber via electrospinning

Ultra-fine polyelectrolyte fibers from electrospinning of poly(acrylic acid)

Preparation of PVP/PLLA Ultrafine Blend Fibers by Electrospinning

Effect of PEO on the Hydrophilicity of PLLA Ultrafine Fibers

Bio-based and Biodegradable Electrospun Fibers Composed of Poly(L-lactide) and Polyamide 4

Experimental Investigation of the Effect of Processing Parameters on the Formation of Electrospun Polyethylene Oxide Nanofibers

Effect of hyperbranched poly(ester amine) additive on electrospinning of low concentration poly(methyl methacrylate) solutions

Preparation and Properties of Poly (vinyl Alcohol) Nanofibers by Electrospinning

Biobased Dyes as Conductive Additives to Reduce the Diameter of Polylactic Acid Fibers during Melt Electrospinning

Electrospinning of ultrafine PVDF/PC fibers from their dispersed solutions

Preparation and characterization of EPDM ultrafine fibers by electrospinning

Morphology control of PLA microfibers and spheres via melt electrospinning

IMPROVEMENT OF POLY(METHYL METHACRYLATE) ELECTROSPUN FIBER UNIFORMITY BY ADDITION OF POLY(ESTER AMINE)

Effect of Solvent Properties on Electrospinning of Amphiphilic Polypeptides

The Effect of Electro blow Spinning Parameters on The Characteristics of Polylactic Acid Nanofibers: Towards Green Development of High-Performance Biodegradable Membrane

Influence of Electrospinning Parameters on the Morphologies of Polyvinyl Acetate Fibers

Liquid Crystal Fibers Produced by Using Electrospinning Technique

Electrospinning process of poly(ether sulfone) fibers

Electrospinning Of Neat And Laponite Nanoclay-Filled Poly(Vinylidene Fluoride)

Preparation of porous hollow polyacrylonitrile ultrafine fibers by coaxial electrospinning