Electrospinning process of poly(ether sulfone) fibers

Qiao Jiaxin,Fang Hongzhao,Yan Yurong

DOI: https://doi.org/10.3969/j.issn.1001-0041.2013.02.008

2013-01-01

Abstract:A good solvent for poly(ether sulfone)(PES),dimethyl formamide(DMF),and its non-good solvent,acetone(AC),were blended into a co-solvent system.The effects of the co-solvent composition and the electrospinning process conditions on the diameter and morphology of the electrospun PES fibers were investigated.The results showed that the DMF/AC ratio played a direct role in regulating the morphology of electrospun PES fibers;the average diameter of the fibers became larger,the number of beads in the fiber mat significantly reduced and the uniformity of the fibers became better when the amount of AC increased in the DMF/AC co-solvent;the average diameter of the fibers became larger while raising the spinning solution concentration and the spinning voltage;and the collection distance had little effect on the average diameter of the fibers;the electrospun PES fiber mat can be obtained with the average fiber diameter of 96 nm under the conditions as followed: 13% PES in spinning solution by mass fraction,spinning voltage 15 kV,collection distance 10 cm,mDMF/mAC of 8.51.5.