Abstract:Randomly packed particle beds (RPPB) are widely used in industry, and their internal flow and heat trans-fer characteristics have a significant impact on the energy efficiency of the overall system. Based on the second law of thermodynamics theory, the correlation equation to predict the exergy transfer coefficient (ETC), exergy transfer Nusselt number (Nu(ex)) within the RPPB is developed, which can reflect temperature and pressure exergy transfer. It effectively reveals the relationship between the role of heat transfer and pressure loss. The experiments are then carried out using stainless-steel particles packed bed with an electric induction heating system to provide a uniform internal heat source. The ambient air is used as the test fluid to cool the heated particles. The pressure drops and forced convection heat transfer char-acteristics of air-cooled high-temperature particles are investigated. The experiments are performed for flows with modified Reynolds number Redh in the range of 811-6810. The effects of cooling air inlet veloc-ity (u(a,in)) and electromagnetic induction heating power (Q(e)) on the experimental results are investigated under different particle sizes (d(p) = 6 and 8 mm). The results show that when d(p) and Q(e) are constant, the overall Nu(ex) decreases exponentially with increasing Redh, and even becomes negative. It means that the heat gain of the air through the RPPB is lower than the pressure loss. The critical Re-dh are 2650 and 5300 when d(p) = 6 and 8 mm, respectively. At fixed d(p) and u(a,i)n, Nu(ex),T decrease linearly with the in-crease of Re-dh. In the case of low Q(e), the exergy transfer between the particles and air is mainly based on pressure exergy transfer. As the Q(e) increases, the temperature exergy transfer gradually increases and dominates, and Nuex shifts from negative to positive. This study delves deeper into the forced convective heat transfer process in RPPB, comprehensively considering the effects of heat transfer and pressure loss. (c) 2021 Elsevier Ltd. All rights reserved.

EXPERIMENTAL INVESTIGATION OF FORCED CONVECTION HEAT TRANSFER IN CENTRIFUGAL FLUIDIZED BED

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

CFD Simulation of an Agitated Gas-Fluidized Bed: Effects of Particle–particle Restitution Coefficient on the Hydrodynamics

Heat Transfer of Batch Simulating Continuous Fluidized Bed with Wet Particles

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

ANALYSIS OF PARTICLES MOTION AND CONVECTION HEAT TRANSFER IN CIRCULATING FLUIDIZED BED

Particle-Fluid Heat Transfer In A Circulating Fluidized Bed

CFD-DEM investigation of flow and heat transfer characteristics in a directly irradiated fluidized bed

Heat transfer in circulating fluidized bed and its modeling

Experimental Study on the Heat Transfer Coefficient Between A Freely Moving Sphere and A Fluidized Bed of Small Particles

EXPERIMENTAL STUDY ON PARTICLE FLOW CHARACTERISTICS IN A CLAPBOARD-TYPE INTERNAL CIRCULATING FLUIDIZED BED REACTOR

Numerical investigation of gas-to-particle cluster convective heat transfer in circulating fluidized beds

Experimental Investigation on Local Particle Volume Fractions Distribution in Offset-Exit Circulating Fluidized Bed

Experimental and Numerical Investigations on Heat Transfer Characteristics of Supercritical Water in a Vertical Tube

Particle-Scale Investigation of Heat Transfer and Erosion Characteristics in a Three-Dimensional Circulating Fluidized Bed

Measurement of Heat Transfer in a 465t/h Circulating Fluidized Bed Boiler

Investigation of Gas-Solid Flow Dynamics and Heat Transfer in Fluidized Beds by Using DEM-LES Coupling Approach

CFD-DEM Simulation of Heat Transfer in Fluidized Beds: Model Verification, Validation, and Application

Experimental Investigation of Flow and Exergy Transfer Characteristics in the Air-Cooled Randomly Packed Particle Bed Based on Second Law Analysis