Abstract:During thermomechanical processing of wrought magnesium alloys, the microstructure and texture continue to evolve as dynamic recrystallization (DRX) proceeds. New grains generated by DRX with a low dislocation density also participate in the texture evolution as the strain increases. However, the controlling mechanisms that drive the evolution are not yet understood. In this work, we studied texture evolution in an extruded Mg–Al–Mn alloy (AM30) during uniaxial compression at 450°C and under various strain rates (ε̇<1.0s-1). The tests were performed along the extrusion direction (ED) and the radial direction (RaD), respectively. Texture evolution was examined by electron backscatter diffraction and X-ray diffraction at different strains. At ε̇<0.1s-1, the effect of twinning was negligible. At ε̇=0.5s-1, a high volume fraction of twins were activated but the twins were consumed by DRX as the strain increased. At ε̇=0.8s-1, twins were not completely consumed by DRX, and the remaining twins had highly incoherent twin boundaries and contributed to the texture. In compression along the ED and with strain rates of ⩽0.5s−1, prismatic slip dominated the texture evolution, and the final orientations clustered around 〈101‾0〉‖ED and〈21‾1‾0〉 || ED, resulting in two stable orientations with a 30° misorientation. At 0.8s−1, basal and pyramidal slip began to dominate the texture evolution at larger strain. In compression along the RaD, basal and pyramidal slip dominated the texture evolution, creating a texture located near 〈101‾2〉–〈101‾5〉–〈21‾1‾9〉–〈21‾1‾5〉and〈101‾0〉–〈21‾1‾0〉 in the inverse pole figure. Texture simulations based on the Sachs and the viscoplastic self-consistent models show a satisfactory correlation between texture evolution and deformation modes.

Influence of Initial Textures on Dynamic Recrystallization and Textures in AZ31 Magnesium Alloys

Effects of Dynamic Recrystallization in Extruded and Compressed Az31 Magnesium Alloy

Dynamic Recrystallization and Texture Development During Hot Deformation of Magnesium Alloy AZ31

Evolution of Microstructure and Texture During Uniaxial Compression of Cast AZ31Mg Alloy at Elevated Temperatures

Effect of initial texture on dynamic recrystallization and deformation mechanisms in AZ31 Mg alloy extruded at 573K

Effects of Dynamic Recrystallization Mechanisms on Texture Evolution in Mg-Gd-Y-Zr-Ag Alloy During Hot Compression

STRAIN-INDUCED TEXTURE DEVELOPMENT IN THE MAGNESIUM ALLOY AZ31

Effect of texture types on microstructure evolution and mechanical properties of AZ31 magnesium alloy undergoing uniaxial tension deformation at room temperature

Effect of Al Concentration on Basal Texture Formation Behavior of AZ-Series Magnesium Alloys during High-Temperature Deformation

Dynamic recrystallization of a wrought magnesium alloy: Grain size and texture maps and their application for mechanical behavior predictions

The Texture Effect on the Dynamic Fracture Properties of Magnesium Alloy AZ31B

Nucleation of Recrystallization in Magnesium Alloy Grains of Varied Orientation and the Impacts on Texture Evolution

Influence of Strain Rate on Dynamic Recrystallization Behavior and Hot Formability of Basal-Textured AZ80 Magnesium Alloy

Microstructure and Texture Evolution of AZ31 Magnesium Alloy During Rolling

Texture and Its Effect on Mechanical Properties of AZ31 Magnesium Alloy

The Role of Recrystallization and Grain Growth in Optimizing the Sheet Texture of Magnesium Alloys with Calcium Addition During Annealing

Direct observation of annealing-driven recrystallization behavior in magnesium alloy at low strain condition

Microtexture evolution in Mg-Y and AZ31 Mg alloy during hot deformation

Texture Evolution During Dynamic Recrystallization in a Magnesium Alloy at 450 °C

Effect of prior strain on continuous recrystallization in AZ31 magnesium alloy after hot deformation

Texture Evolution During Static Recrystallization of Cold-Rolled Magnesium Alloys