Abstract:Superplastic forming is considered a highly efficient technique for shaping intricate components from titanium matrix composites (TMCs). In this work, high-temperature TMCs with 5 vol% (TiBw + TiCp) reinforcements underwent superplastic tensile tests at various temperatures and strain rates. The results demonstrated that at all deformation temperatures (900 °C–1050 °C) and strain rates (5 × 10−3 s−1 to 10−4 s−1), the elongation of composite sheets surpassed 100%. The strain rate of 10−3 s−1 and a temperature of 1000 °C were found to yield the maximum elongation of 328.1%. At 900 °C, the matrix grains maintain a lamellar morphology during the main stage of deformation, and dynamic recovery (DRV) is the primary mechanism of matrix softening. At 1000 °C, wide-range dynamic recrystallization (DRX) takes place, and grain boundary slip coordinated by grain rotation is the main mechanism of deformation. At 1050 °C, the matrix grains undergo DRX and grow rapidly by migration, and the number of grain boundaries decreases dramatically, resulting in poor superplastic qualities. In the early stages of superplastic deformation, micropores sprout at the triple grain boundaries and at the interfaces between the reinforcements and the matrix. As the deformation proceeds, the micropores extend along the tensile direction and connect with each other to form cavity stringers (CS). The distance between the CS rapidly narrows as the stretching process continues, and eventually the CS links horizontally to form cavity coalescence (CC). Micropore dilatation around the reinforcements causes debonding and cavitation, leading to material failure.

High-strain-rate superplasticity of metal matrix composites

High Strain Rate Superplasticity of MMCs

The Development of High Strain Rate and Low Temperature Superplasticity in Aluminum Matrix Composites

Influence of plastic strain localisation on the mechanical properties of metal matrix composites

High Strain Rate Superplasticity of in situ Al 3 Zr/6063Al Composites

The Progress in Research of the Plasticity and Superplasticity of Aluminum and Titanium Matrix Composites

Experimental Investigation and Modelling of Hot Forming B4C/AA6061 Low Volume Fraction Reinforcement Composites

Numerical Simulation of Strain Rate Effect on the Inelastic Behavior of Metal Matrix Composites

A dislocation-based, strain–gradient–plasticity strengthening model for deformation processed metal–metal composites

Microstructure and high strain rate superplasticity of in situ composite synthesised from aluminium and nanoZrO2 particles by powder metallurgy

High strain rate superplasticity of TiNp/lN90Al composite prepared by powder metallurgy method

High Strain Rate Superplasticity in Al-Zn-Mg-Based Alloy: Microstructural Design, Deformation Behavior, and Modeling

Progress of Research Forming of Metal Matrix Composites

Extraordinary superplasticity at low homologous temperature and high strain rate enabled by a multiphase nanocrystalline network

Superplastic Deformation of a Heat-Resistant Al–Cu–Mg–Ag–Mn Alloy

Achieving high strain rate superplasticity in an Al-Cu-Li alloy processed by thermo-mechanical processing

Superplastic deformation of in situ synthesized TiC/7715D matrix composite

Superplastic deformation behavior of 5 vol% (TiBw+TiCp)/Ti matrix composite sheets with lamellar microstructure

In-situ surface study on the mechanism of high-strain-rate superplasticity in an Al–Cu–Li alloy

Deformation mechanism and microstructure evolution during superplastic deformation of friction stir processed CoCrFeNiMn high entropy alloy

Current Status and Development Trends of Study on Superplastic Magnesium Alloys