Abstract:Blank holder force (BHF) is one of the important process parameters in the deep drawing process. BHF helps produce defect-free components by controlling metal flow during the deep drawing process. If BHF is low, it causes wrinkling; otherwise, it causes the sheet to rupture. Therefore, optimization of BHF is an important issue in industries. One of the effective approaches to determining optimal BHF is to study forming force, thickness distribution, and wrinkles to produce a deep-drawn cup. The main function of this approach is that it minimizes the maximum forming force and prevents process limits. Therefore, this study aims to investigate the relationship between the BHF and forming force through experimental and simulation results. In addition, the effect of BHF on the thickness distribution and wrinkling is considered. Hence, numerical and experimental methods were employed for St14 and SS304L sheets with thicknesses of 0.5, 1, and 1.5 mm to achieve the objectives. Firstly, the simulation of the process was performed to study the mechanical behavior. Then, a set of experimental tests were conducted to validate the simulations. Finally, utilizing the experimental and numerical results, the optimal BHF value was determined. It was observed that the maximum thinning and maximum forming force are related to the forming process without BHF. Moreover, when the wrinkling at the edge of the part was removed by gradually increasing BHF, the minimum values of forming force and thinning were obtained. According to the investigations carried out on three thicknesses, it was observed that by reducing the thickness from 1.5 to 0.5 mm, the maximum forming force decreases in both SS304L and St14 sheets. However, the acquired results showed that the minimum optimal BHF is obtained in both sheets at a thickness of 1.5 mm. Overall, this research provides valuable experimental and numerical guidance for implementing the deep drawing process to manufacture cylindrical parts with minimum forming force required to save energy consumption.

Determination of blank holder force in sheet metal deep drawing process

Blank-Holder Force Control in Deep Drawing of Rectangular Parts of AZ31 Magnesium Alloy Sheet

Research on the Critical Blank Holder Force of Elliptical Heads

Study on Calculation of Black Holder Force in Deep-Drawing Rectangle

Determination of optimal blank holder force trajectories for segmented binders of step rectangle box using PID closed-loop FEM simulation

A New Strategy for the Optimization of Variable Blank Holder Force in Sheet Metal Forming

Deep Drawing of Rectangle Parts Using Variable Blank Holder Force

Formability and Forming Load Analysis of Sheet Drawing under BHF and BHG

The Study of Load Curve of Critical Wrinkless Variable Blank Holder Force in the Process of Deep Drawing Cylinder Parts

Experimental and numerical investigation to determine the optimal blank-holder force in deep drawing process based on forming force for SS304L and St14 sheets

Novel algorithm for determining optimal blankholder forces in deep drawing of aluminum alloy sheet

A New Strategy to Optimize Variable Blank Holder Force Towards Improving the Forming Limits of Aluminum Sheet Metal Forming

The Effect of Variable Blank-Holder Forces on Formability of Ractangle Box Deep Drawing

Design and Sensitivity Analysis of Blank Holding Force for High Strength Steel Sheet

Numerical Simulation of Warm Deep Drawing of AZ31 Magnesium Alloy Sheet with Variable Blank Holder Force

Numerical and Physics Simulations of Variable Blank Holder Force in Process of Deep Drawing Complex Overlay

Development of forming process for deep drawing of square cup with optimized blank holder pressure

Effect of variable blank-holder forces on the formability of aluminum alloy sheets during sheet metal forming

Study on Optimized Control of BHF

The Influence of Variable Blank Holder Force on the Formability of Complex Parts

Control of the blank-holder force to improve the formability of aluminum alloy sheet