Abstract:Pumped storage power is the most mature and cleanest energy in the world, which is universally used in energy recovery fields. As the pumped storage units operate at part-load conditions, typical unstable flow phenomena are universally observed. Guaranteeing the operation stability of the unit is being increasing significant. Since much attention has been paid to the unstable flow characteristic in the hump region, the interaction between the unstable flow and hump characteristic is seldom involved. In present research, comprehensive analysis is systematically conducted to explore unstable flow and its interaction with the hump characteristic in a pump-turbine operated at pump mode. Three typical models, corresponding to the test model, small lean angle model (lean angle theta = 2 degrees) and medium lean angle model (lean angle theta = 10 degrees) representing different flow conditions, i.e., "hump peak", "hump valley" and "stable condition" respectively, are selected for analysis. First, characteristic curves predicted by a modified shear stress transport k-omega partially averaged Navier-Stokes model show good agreements with the experiment data. Then, comprehensive discussions are performed in the blade passage of runner and guide vane. In the runner blade passage, the scale of flow separation near the suction side of the blade increases with increment of the lean angle. In the guide vane, although rotating stall is observed in three models, its scale and intensity are largest under the "hump peak" condition, and alleviated under the "hump valley" and "stable condition". After frequency and its dynamics analysis, it is found that one dominant frequency of 0.088f(n) is induced by the rotating stall evolution. Moreover, as the rotating stall is alleviated under the "stable condition", the dominant frequency captured by the proper orthogonal decomposition (POD) method is transferred to 3f(n), and the hump is also alleviated.

Analysis of Relation Between Characteristics of Pump-Turbine Runner and Transition of Pumped-Storage Power Station

Analysis of Inter-blade Vortex and Runner Blades Force of Pump Turbine during Load Rejection Period

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Distribution Features of Flow Patterns and Pressure Pulsations of Pump-Turbine in Five Operating Modes on the Four-Quadrant Plane

Analysis of Flow and Runner Dynamic Response Characteristics under Pump Conditions of Variable-Speed Pump Turbine

Differences of Flow Patterns and Pressure Pulsations in Four Prototype Pump-Turbines during Runaway Transient Processes

Investigation into the Flow Details of Runner Region in A Pump Turbine at Off-Design Conditions

Predicting pump-turbine characteristic curves by theoretical models based on runner geometry parameters

Numerical Investigation on the Unstable Flow and Its Interaction with the Hump Characteristic in a Pump Turbine at Pump Mode

Dynamic Response of a Pump-Turbine Runner During Turbine's Mode Starting Up

Analysis of Flow Characteristics in Pumped Storage Unit During Start-Up in Turbine Mode

Research and optimization of performances of a pump turbine in pump mode

Analysis of Vortex Evolution in the Runner Area of Water Pump Turbine under Runaway Conditions

CFD simulation of the pump trip runaway transient process of a pumped-storage power plant with head 700 m

Effect of Operating Head on Dynamic Behavior of a Pump–Turbine Runner in Turbine Mode

Mechanism and Influence Factors of Hydraulic Fluctuations in a Pump-Turbine

Comprehensive Hydraulic Performance Improvement in a Pump-Turbine: an Experimental Investigation

Numerical investigation of hydraulic instability of pump-turbines in fast pump-to-turbine transition

Numerical Investigation on Transient Flow of A High Head Low Specific Speed Pump-Turbine in Pump Mode

Transient Analysis of a Multi-Unit Pumped Storage System During Load Rejection Process

Study on Transient Flow Characteristics of Pump Turbines During No-Load Condition in Turbine Mode Startup