Abstract:In the active flight phase, the spacecraft suffers the rigorous external vibration environment which comes from the engine at the bottom of rocket. In course of the ground test, the shaker simulates such excitation through the base movement, and the modal parameters identification method which employs the vibration test data is to the more extent in line with the operating state. In this paper, a specified method is applied for parameter estimation of lumped-mass mechanical system in the vibration test. The modal parameters under the fixed and free–free constrained state can be identified at the same time by this technique. In addition, when the analytical model which includes the test article and the shaking table is adopted, the relations between the response transfer function (RTF) and frequency response function (FRF) are clarified, and some misconceptions in the engineering practice are cleared. Because of the uncertain of the connection impedance between the test article and the shaking table, only the partial parameters of the fixed mode can be identified, such as natural frequency, modal damping ratio and modal shape. As the interface force transfer function (IFTF) can eliminate the influence of the connection impedance and the fixed impedance matrix of the test piece is transformed into the free impedance matrix, the identified parameters of the free mode are complete. Furthermore, the influence of the constraint degree of freedom (DOF) on the parameter identification of the IFTF is discussed preliminarily. Finally, the numerical simulation and the vibration test of discrete structure verify the validity of the proposed method.

Vibration control of flexible space structures based on in-orbit identification

ON-ORBIT IDENTIFICATION AND VIBRATION CONTROL FOR SOLAR ARRAYS WITH LOW AND CLOSE FREQUENCIES

Active Control on Coupled Bending-Torsion Vibration of Two-Link Space Flexible Component

Time Series Based Identification in Vertical Tail Piezoelectric Smart Structure Control System

DYNAMIC CONTROL OF TENSION STRUCTURES

VIBRATION CONTROL OF FLEXIBLE SPACE STRUCTURES WITH DIRECT VELOCITY FEEDBACK

Model Identification of Active Vibration Control in Flexible Structure

Attitude Control For Flexible Spacecraft With Swinging Components

On-orbit modal identification for vibration suppression of flexible aerospace structure using reaction wheel actuator

Non-Contact Measurement and Identification Method of Large Flexible Space Structures in Low Characteristic Scenes

Structural Flexibility Effect on Spaceborne Solar Observation System's Micro-Vibration Response

Suppressing the Thermally Induced Vibration of Large-Scale Space Structures via Structural Optimization

Vibration Suppression of a Large Flexible Spacecraft for On-Orbit Operation

Modeling and Observer-Based Vibration Control of a Flexible Spacecraft With External Disturbances

Micro-vibration control of spaceborne payload with smart parallel struts

Vibration Control of Flexible Structures with Close Modes Using Adaptive Inverse Control Method

The maximum likelihood identification of flexible structure in frequency domain

Prescribed modal vibration control and disturbance load analysis of rigid-flexible satellites

Modal Parameter Identification of Structure under Base Excitation Using Vibration Test Data

Active Vibration Control of a High-Speed Flexible Robot Using Variable Structure Control

Prediction Technique and Measuring Device for Coupled Disturbance Forces from Large Equipment in the Spacecraft