Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Order tracking filtering based on instantaneous frequency estimation and zero-phase distortion digital filtering

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Tacholess Void-Kalman Order Tracking of Rotating Machinery

A Tacho-Less Order Tracking Technique for Large Speed Variations

The Study of Vibration Signal Zero Phase Shifting Filter Technology in Rotating Machinery

ORDER TRACKING OF ROTATING MACHINERY BASED ON INSTANTANEOUS FREQUENCY ESTIMATION

Order Spectrogram Visualization for Rolling Bearing Fault Detection under Speed Variation Conditions

Gabor Order Tracking Filtering Technology in Rotary Machinery

An Online Tacholess Order Tracking Technique Based on Generalized Demodulation for Rolling Bearing Fault Detection

Order Tracking Method Based on Time-Frequency Analysis

An Adaptive and Tacholess Order Analysis Method Based on Enhanced Empirical Wavelet Transform for Fault Detection of Bearings with Varying Speeds

Pseudo-Speed Tracking Order Analysis for Non-Stationary Vibration Signals of Rotating Machinery

A novel tacholess order tracking method for gearbox vibration signal based on extremums search of gearmesh harmonic

Research on order tracking based on Hilbert-Huang transform

Novel method of order tracking analysis based on energy centrobaric correction

Extracting Fundamental Frequency During Rotating Machine Start-Up or Shut-Down via Fractional Domain Filtering

Single Order Harmonic Detection with Incremental Algorithm of DFT

Dynamic time warping based instantaneous frequency estimation for rotating machineries under non-stationary operating conditions

Current-Aided Dynamic Time Warping for Planetary Gearbox Fault Detection at Time-Varying Speeds

A Modified Tacho-Less Order Tracking Method for the Surveillance and Diagnosis of Machine under Sharp Speed Variation

Study of Time-Frequency Order Tracking of Vibration Signals in Engine Speed Changing Stage