Abstract:The present study experimentally investigated the non-monotonous evolutions as well as the maximum lengths of the flame base extent (attached to the ground) and horizontal flame extent (deflected flame tip) of buoyant turbulent diffusion flames subject to relative strong cross flows of air. These transition behaviors and quantities have not been quantified in the literature, meanwhile are essential for quantifying this boundary layer diffusion combustion characteristics associated with complex fluid dynamics and air entrainment behavior, as well as for the estimation of hazardous impact of the flame upon the downstream areas. Four square burners with dimensions of 8, 10, 15 and 20 cm were used in the present work employing propane as fuel supplied with various heat release rates. The flame base extent and the horizontal flame extent were measured under cross flows provided by a wind tunnel with the cross flow air velocity with range of 0 m/s to a relative strong level, 6.0 m/s. It is shown in the results that the flame base extent and horizontal flame extent first increases with cross flow air speed at relative lower range, which is in accordance with observations reported in the literatures. However, a new phenomenon is found that once the cross flow air velocity is beyond a critical value, both these two horizontal extents of the flame decreased when the air speed is further increased. The observed two-regime behavior is then analyzed based on three dimensionless parameters including Froude number representing the counteraction of the cross flow with the buoyant flow, dimensionless heat release rate, and the ratio of gaseous fuel density to the ambient air density. New correlations are proposed to describe the two-regime evolution behavior for flame base extent and horizontal flame extent with increasing cross flow air speed, as well as maximum extents that can be reached. These new observations and proposed correlations provide an essential base to quantify the buoyant turbulent diffusion flame boundaries in relative strong wind conditions.

AN EXPERIMENTAL STUDY ON DIFFUSION CHARACTERISTICS OF THE GAS-SOLID TWO-PHASE BURNER FLOW WITH SIDE FLOW

Experimental Investigation on Flow Structures and Mixing Mechanisms of a Gas–solid Burner Jet

E207 USING LIGHT FLUCTURATION METHOD TO STUDY THE GAS-SOLID BURNER FLOW

Studies of Gas-Solid Two-Phase Flow Diffusion Based on Optical Wave Method

TEST STUDY ON OUTLET FLOW FIELD PERFORMANCE FROM WAVE-SHAPED COMBUSTION-STABILIZING BODY OF THE CONCENTRATION TUNABLE RICH/LEAN BURNERS

THE DIFFUSION CHARACTERISTICS OF THE HORIZONTAL FUEL RICH-LEAN GAS-SOLID BURNER FLOW

Experimental Study on Gas-Solid Two-Phase Flow Characteristics of a Vertical Cyclone Combustor System

Experimental Measurement of Gas-Solid Two-Phase Flow of a Swirl Burner by Optical Wave Method

Two-Phase Flow Measurements of a Gas−Solid Jet Downstream of Fuel Rich/Lean Burner

Experimental study on cold two-phase flow in swirl burner exit

Flow Characteristic Of A New Type Of Double-Channel Air Burner In Direct Flow Pulverized Coal Boiler

Diffusion Characteristics of Colliding Rich-Lean Gas-Solid Two-Phase Flows

An Experimental Study and Analysis on Maximum Horizontal Extents of Buoyant Turbulent Diffusion Flames Subject to Relative Strong Cross Flows

Experimental studies on gas-particle flows in a swirl burner by PDPA measurements

THE NUMERICAL INVESTIGATION ON THE TRANSIENT CHARACTERISTICS OF THE GAS-SOLID TWO-PHASE FUEL RICH-LEAN BURNER FLOW

TEST AND STUDY ON DEVELOPING COMPOSITE BURNERS WITH CAPABILITY OF STABLE COMBUSTION UNDER LOW LOAD AND SLAGGING PREVENTION UNDER HIGH LOAD

STUDY ON SEPARATION AND RESISTANCE PROPERTIES OF VENTURI RICH/ LEAN PULVERIZED COAL BURNERS

Experimental and Numerical Study of a Two-Stage Swirl Burner

Improving mixing and gasification characteristics in an industrial-scale entrained flow gasifier with a novel burner

Systematic numerical simulation and experimental study of gas-solid two-phase flow, heat transfer and combustion in W-shape flame boiler furnace

Effect of Tooth-Type Exit Structure on Gas-Solid Flow Field Adjacent to Exit of Dense-Dilute Burner