Abstract:This article presents an application-specific integrated circuit (ASIC) for catheter-based 3-D ultrasound imaging probes. The pitch-matched design implements a comprehensive architecture with high-voltage (HV) transmitters, analog front ends, hybrid beamforming analog-to-digital converters (ADCs), and data transmission to the imaging system. To reduce the number of cables in the catheter while maintaining a small footprint per element, transmission (TX) beamforming is realized on the chip with a combination of a shift register (SR) and a row/column (R/C) approach. To explore an additional cable-count reduction in the receiver part of the design, a channel with a combination of time-division multiplexing (TDM), subarray beamforming, and multi-level pulse amplitude modulation (PAM) data transmission is also included. This achieves an 18-fold cable-count reduction and minimizes the power consumption in the catheter by a load modulation (LM) cable driver. It is further explored how common-mode interference can limit beamforming gain and a strategy to reduce its impact with local regulators is discussed. The chip was fabricated in TSMC 0.18- $\mu$ m HV BCD technology and a 2-D PZT transducer matrix of 16 $\times$ 18 elements with a pitch of 160 $\mu$ m and a center frequency of 6 MHz was manufactured on the chip. The system can generate all required TX patterns at up to 30 V, provides quick settling after the TX phase, and has an reception (RX) power consumption of only 1.12 mW/element. The functionality and operation of up to 1000 volumes/s have been demonstrated in electrical and acoustic imaging experiments.

An All-Purpose Real-Time Singleboard Ultrasound System Based On Pci

High Resolution X-Ray Medical Sequential Image Acquisition and Processing System Based on PCI Interface

Ultrasonic Phased Array System Based On Pci Bus

Logical Architecture Design of Integrated Electronic System with High Real-Time and Reliability in ZDPS-2 Pico-Satellite

6-Channel High-speed Parallel Data Acquisition Card for Ultrasonic Signal Based on PCI Bus

Design of Intelligent Ultrasonic Power Source Based on FPGA

Research of a multi-channel neural signal acquisition system based on PCI and DSP

PCI Data Acquisition System Based on DSP

A Pitch-Matched High-Frame-Rate Ultrasound Imaging ASIC for Catheter-Based 3-D Probes

Design of a Digital Receive Beamformer ASIC Based Ultrasound Imaging System Prototype

A 128-ch Δ-Σ ADC based mixed signal IC for full digital beamforming Wireless handheld Ultrasound imaging system

Low-power Receive Electronics for a Miniature Real-Time 3D Ultrasound Probe

A Programmable Ultrasound Platform for Multi-Gate Doppler Measurement

A Pitch-Matched Front-End ASIC with Integrated Subarray Beamforming ADC for Miniature 3-D Ultrasound Probes

A 16-Channel 50ms/s 14bit Pipelined-SAR ADC for Integrated Ultrasound Imaging Systems.

An element-matched band-pass delta-sigma ADC for ultrasound imaging

A Front-End ASIC with High-Voltage Transmit Switching and Receive Digitization for 3-D Forward-Looking Intravascular Ultrasound Imaging.

A High-Frequency Mechanical Scanning Ultrasound Imaging System

Open system for micro-ultrasound

A System-on-Chip Solution for Point-of-Care Ultrasound Imaging Systems: Architecture and ASIC Implementation

Ultra-Low Phase Noise Frequency Division With Array of Direct Digital Synthesizers