Abstract:A 2D ultrasonic array is the ultimate form of a focused ultrasonic system, which enables electronically focusing beams in a 3D space. A 2D array is also a versatile tool for various applications such as 3D imaging, high-intensity focused ultrasound, particle manipulation, and pattern generation. However, building a 2D system involves complicated technologies: fabricating a 2D transducer array, developing a pitch-matched ASIC, and interconnecting the transducer and the ASIC. Previously, we successfully demonstrated 2D capacitive micromachined ultrasonic transducer (CMUT) arrays using various fabrication technologies. In this paper, we present a 2D ultrasonic transmit phased array based on a 32 × 32 CMUT array flip-chip bonded to a pitch-matched pulser ASIC for ultrasonic neuromodulation. The ASIC consists of 32 × 32 unipolar high-voltage (HV) pulsers, each of which occupies an area of 250 μm × 250 μm. The phase of each pulser output is individually programmable with a resolution of 1/fC/16, where fC is less than 10 MHz. This enables the fine granular control of a focus. The ASIC was fabricated in the TSMC 0.18- μm HV BCD process within an area of 9.8 mm × 9.8 mm, followed by a wafer-level solder bumping process. After flip-chip bonding an ASIC and a CMUT array, we identified shorted elements in the CMUT array using the built-in test function in the ASIC, which took approximately 9 minutes to scan the entire 32 × 32 array. A compact-form-factor wireless neural stimulator system-only requiring a connected 15-V DC power supply-was also developed, integrating a power management unit, a clock generator, and a Bluetooth Low-Energy enabled microcontroller. The focusing and steering capability of the system in a 3D space is demonstrated, while achieving a spatial-peak pulse-average intensity ( ISPPA) of 12.4 and 33.1 W/ cm2; and a 3-dB focal volume of 0.2 and 0.05 mm3-at a depth of 5 mm-at 2 and 3.4 MHz, respectively. We also characterized transmission of ultrasound through a mouse skull and compensated the phase distortion due to the skull by using the programmable phase-delay function in the ASIC, achieving 10% improvement in pressure and a tighter focus. Finally, we demonstrated a ultrasonic arbitrary pattern generation on a 5 mm × 5 mm plane at a depth of 5 mm.

Ultrasonic Phased Array System Based On Pci Bus

High Resolution X-Ray Medical Sequential Image Acquisition and Processing System Based on PCI Interface

An All-Purpose Real-Time Singleboard Ultrasound System Based On Pci

6-Channel High-speed Parallel Data Acquisition Card for Ultrasonic Signal Based on PCI Bus

Multi-channel drive system of phased array based on DDS chips

Real Time Acquisition System Of Ultrasound Linear Phased Array

An Automatic Test System for a Spaceborne Chip of a Temperature-Sensing Controller

Design of an Ultrasonic Phased Array Launch System Based on Gigabit Ethernet Transmission

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

Ultrasonic Dynamic Plane Wave Imaging for High-Speed Railway Inspection

The Ultrasonic Testing System with PCI Bus Based Four-Channel Data Acquisition Card for Train Axles

Ultrasonic Phased Array Process Tomography System for Multiphase Medium Imaging

Phased array ultrasonic detection using equal height focusing algorithm

A 24-Ghz Low-Cost Continuous Beam Steering Phased Array for Indoor Smart Radar

A Wearable Ultrasonic Neurostimulator-Part II: A 2D CMUT Phased Array System With a Flip-Chip Bonded ASIC

AUTD3: Scalable Airborne Ultrasound Tactile Display

Design of a Digital Receive Beamformer ASIC Based Ultrasound Imaging System Prototype

A $K$ -Band Portable FMCW Radar with Beamforming Array for Short-Range Localization and Vital-Doppler Targets Discrimination

Multi-Frequency Transmitting Beamforming Algorithm Based on Cross Array

Simulation and Implication of a two-dimensional phased array flexible ultrasound system for tissue characterization

Design of RFSoC-based Digital Phased Array Feed (PAF) and Hybrid Architecture Beamforming System