Abstract:Despite being an old detector concept, position-sensitive parallel-plate avalanche counters (PPACs) remain widely used today for heavy-ion position and timing measurements. In modern rare isotope beam facilities and large-acceptance fragment separators, PPACs are used to characterize beam properties (diagnostics), facilitate beam delivery (tuning), and provide event-by-event beam tracking for particle identification (PID). Most popular particle localization methods in PPAC detectors are based on strip electrodes electrically connected to resistive-chain circuits or delay lines. More exotic systems include optical readouts based on recording electroluminescence light with high-granularity photodetector arrays or high-resolution resistive anode electrodes. PPACs with conventional resistive-chain or delay-line readouts achieve typical position and time resolutions of below 1 mm ( σ ) and around 150 ps ( σ ), respectively. In addition, delay-line systems are capable of counting rates above several hundred kHz for beam areas of a few millimeters square, and around 1 MHz for larger beam sizes. Resistive-chain readouts have limited rates of a few tens of kHz. A review of the operation principles and performance of PPAC detectors is presented in this paper. We will discuss decades-long experience building and operating PPACs developed at the National Superconducting Cyclotron Laboratory, and then refined at the Facility for Rare Isotope Beams (FRIB), mostly focusing on the delay-line readout technique (DLPPAC). We will also discuss problems that arise due to electric discharges at high rates and briefly describe ongoing developments at FRIB. https://doi.org/10.1103/PhysRevAccelBeams.27.044801 Published by the American Physical Society under the terms of the Creative Commons Attribution 4.0 International license. Further distribution of this work must maintain attribution to the author(s) and the published article's title, journal citation, and DOI. Published by the American Physical Society

Performance Test of PPAC in Different Gases

A Large Position-sensitive PPAC

Development of Parallel Plate Avalanche Counter PPAC for BigRIPS fragment separator

Development of a Parallel-Plate Avalanche Counter with Optical Readout (O-PPAC)

The development of segmented electrode thin-film parallel plate avalanche counter (PPAC)

Development of high position resolution parallel plate avalanche chambers

Delay-line PPAC for Intermediate Energy Light Ions

Performance Testing of a Long-Strip Two-End Readout Multi-Gap Resistive Plate Chamber

Development of Parallel Plate Avalanche Counter for Heavy Ion Collision in Radioactive Ion Beam

Efficiency of Position Sensitive PPAC for Various Ions

Parallel-plate avalanche counters for heavy-ion beam tracking: History and mysteries

Development of fast-response PPAC with strip-readout for heavy-ion beams

A high rate and high timing photoelectric detector prototype with RPC structure

Development of parallel plate avalanche counters for prompt fission neutron spectrum measurement

Study of the ecological gas for MRPCs

Study of an avalanche-mode resistive plate chamber

Performance of the CAT-TPC Based on Two-Dimensional Readout Strips

Study on the Position Resolution of Resistive Plate Chamber

Gas related effects on multi-gap RPC performance in high luminosity experiments

The High-Rate Sealed MRPC to Promote Pollutant Exchange in Gas Gaps: Status on the Development and Observations

Performance of Two Different Modules of Long-Strip Multi-Gap Resistive Plate Chamber