Abstract:In the CBM (Compressed Baryonic Matter) experiment constructed at the Facility for Anti-proton and Ion Research (Fair) at GSI, Darmstadt, Germany, MRPC(Multi-gap Resistive Plate Chamber) is adopted to construct the large TOF (Time-of-Flight) system to achieve an unprecedented precision of hadron identification, benefiting from its good time resolution, relatively high efficiency and low building price. We have developed a kind of double-ended readout strip MRPC. It uses low resistive glass to keep good performance of time resolution under high-rate condition. The differential double stack structure of 2x4 gas gaps help to reduce the required high voltage to half. There are 24 strips on one counter, and each is 270mm long, 7mm wide and the interval is 3mm. Ground is placed onto the MRPC electrode and feed through is carefully designed to match the 100 Ohm impedance of PADI electronics. The prototype of this strip MRPC has been tested with cosmic ray, a 98% efficiency and 60ps time resolution is gotten. In order to further examine the performance of the detector working under higher particle flux rate, the prototype has been tested in the 2014 October GSI beam time and 2015 February CERN beam time. In both beam times a relatively high rate of 1 kHz/cm2 was obtained. The calibration is done with CBM ROOT. A couple of corrections has been considered in the calibration and analysis process (including time-walk correction, gain correction, strip alignment correction and velocity correction) to access actual counter performances such as efficiency and time resolution. An efficiency of 97% and time resolution of 48ps are obtained. All these results show that the real-size prototype is fully capable of the requirement of the CBM-TOF, and new designs such as self-sealing are modified into the strip counter prototype to obtain even better performance.

Performance of the CAT-TPC Based on Two-Dimensional Readout Strips

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

A Design Implementation of the Central Process Module for an In-Beam PET in HICTD

Performance of a Small AT-TPC Prototype

Performance Study of a GEM-TPC Prototype Using Cosmic Rays

Performance Study of a Novel Sampling TPC Prototype Detector Based on THGEM

Performance of TPC Detector Prototype Integrated with UV Laser Tracks for the Circular Collider

Performance of the Micro-Tpc Reconstruction for GEM Detectors at High Rate

Study of Gas Properties for GEM-Based TPC

Design of a Neutron-Tpc Prototype and Its Performance Evaluation Based on an Alpha-Particle Test

Performance Study of the Multi-purpose Time Projection Chamber (MTPC) Using a Four-Component Alpha Source

A Muti-channel Distributed DAQ for n-TPC

Status and prospects of TPC module and prototype at high luminosity <i>Z</i> physics on CEPC

A Multi-Channel Distributed DAQ for N-Tpc

Recent Performance Studies of the GEM-based TPC Readout (DESY Module)

Performance Study of the Neutron-Tpc

Design and commissioning of a 600 L Time Projection Chamber with Microbulk Micromegas

The Design of Time Projection Chamber for Fission Cross-Section Measurements

Fudan Multi-purpose Active TArget Time Projection Chamber (fMeta-TPC) for Photonnuclear Reaction Experiments

The ALICE TPC, a large 3-dimensional tracking device with fast readout for ultra-high multiplicity events

Development and test of a real-size MRPC for CBM-TOF