Abstract:Based on the recently constructed n-body potential, both molecular dynamics and Monte Carlo simulations revealed that the Al-Zr amorphous alloy or metallic glass can be obtained within the composition range of 24–66 at. % Zr. The revealed composition range could be considered the intrinsic glass-forming range and it quantitatively indicates the glass-forming ability of the Al-Zr system. The underlying physics of the finding is that, within the composition range, the amorphous alloys are energetically favored to form. In addition, it is proposed that the energy difference between a solid solution and the amorphous phase could serve as the driving force of the crystalline to amorphous transition and the driving force should be sufficiently large for amorphization to take place. The minimum driving forces for fcc Al-based and hcp Zr-based Al-Zr solid solutions to amorphize are calculated to be about −0.05 and −0.03 eV/atom, respectively, whereas the maximum driving force is found to be −0.23 eV/atom at the alloy stoichiometry of Al60Zr40. A thermodynamics parameter γ¯, defined as the ratio of the driving force to the formation energy of the solid solution, is further proposed to indicate the glass-forming ability of an Al-Zr alloy. Thermodynamics calculations show that the glass-forming ability of the Al56Zr44 alloy is the largest, implying that the Al56Zr44 amorphous alloy is more ready to form than other alloys in the Al-Zr system. Besides, Voronoi analysis found that there exists a strong correlation between the coordinate number and structure. Amorphization could result in increase of coordinate numbers and about 1.5% volume-expansion. The volume-expansion induced by amorphization can be attributed to two factors, i.e., the total bond number of the Al-Zr amorphous phase is greater than that of the corresponding solid solution, and the averaged bond length of the Al-Zr amorphous phase is longer than that of the corresponding solid solution. For the Al-Zr alloys, especially for the Al-Zr amorphous phase, there exists a negative chemical micro-inhomogeneity in the alloys, suggesting that metallic bonds prefer to be formed between the atoms of dissimilar species. Finally, it is found that there is a weak correspondence between the bond-angle distributions of Al-Zr amorphous alloys and the solid solutions. It is further suggested that the configuration of Al-Zr amorphous alloys embodies some hybrid imprint of bcc, fcc, and hcp structures. More interestingly, the short-range order is also observed in the bond-angle distributions.

Low Temperature Specific Heat of a Typical Glass Forming Alloy

Critical Cooling Rate and Thermal Stability for a Ti–Zr–Ni–Cu–Be Metallic Glass

Critical Cooling Rates For Glass Formation In Zr66al9cu16ni9

LOW TEMPERATURE SPECIFIC HEAT ON BULK AMORPHOUS Zr-Ti-Cu-Ni-Be ALLOY

Chemical short-range order domain in bulk amorphous alloy and the prediction of glass forming ability

Thermal Analysis by Means of Differential Scanning Calorimetry of the Characteristic Thermodynamic Temperatures of a Cu-Zr-Al Bulk Metallic Glass

Glass Forming Abilities of Binary Cu100−xZrx (34, 35.5, and 38.2 At. %) Metallic Glasses: A LAMMPS Study

Deformation and Crystallization of a Zr41.2Ti13.8Cu12.5Ni10Be22.5 Bulk Metallic Glass in the Supercooled Liquid Region

Short-to-medium-range order in Mg65Cu25Y10 metallic glass

Cooling Rate Dependence of Structural Order in Al90Sm10 Metallic Glass

Non-isothermal crystallization kinetics and glass-forming ability of Ti41Zr25Be28Fe6 bulk metallic glass investigated by differential scanning calorimetry

Microstructure and crystallization in Cu50Zr45Al5 metallic glass

Thermal Stability and Mechanical Properties of Zr50Ti5Cu18Ni17Al10 Bulk Metallic Glass

A Relationship Between Glass-Forming Ability and Reduced Glass Transition Temperature Near Eutectic Composition

Formation, Thermal Stability and Mechanical Properties of Ti42.5Zr7.5Cu40Ni5Sn5 Bulk Metallic Glass

Evidence of Icosahedral Short-Range Order in Zr70cu30 and Zr70cu29pd1 Metallic Glasses

Specific heat at low temperatures in quasiplanar molecular crystals: Where do glassy anomalies in minimally disordered crystals come from?

Effects of crystallization on low-temperature specific heat capacity of Cu60Zr20Hf10Ti10 bulk metallic glass

Non-isothermal crystallization kinetics and glass-forming ability of Ti 41 Zr 25 Be 28 Fe 6 bulk metallic glass investigated by differential scanning calorimetry

Superplastic deformation behavior of Zr41.25Ti13.75Ni10Cu12.5Be22.5 bulk metallic glass in the supercooled liquid region

Formation and structure of Al-Zr metallic glasses studied by Monte Carlo simulations