Abstract:The stability/instability behavior of polystyrene (PS) films with tunable thickness ranging from higher as-cast to lower residual made on Si substrates with and without native oxide layer was studied in this paper. For further extraction of residual PS thin film (hresi) and to investigate the polymer–substrate interaction, Guiselin’s method was used by decomposing the polymer thin films in different solvents. The solvents for removing loosely adsorbed chains and extracting the strongly adsorbed irreversible chains were selected based on their relative desorption energy difference with polymer. The PS thin films rinsed in chloroform with higher polarity than that of toluene showed a higher decrease in the residual film thickness but exhibited earlier growth of holes and dewetting in the film. The un-annealed samples with a higher oxide film thickness showed a higher decrease in the PS residual film thickness. The effective viscosity of PS thin films spin-coated on H-Si substrates increased because of more resistance to flow dynamics due to the stronger polymer–substrate interaction as compared to that of Si-SiOx substrates. By decreasing the film thickness, the overall effective mobility of the film increased and led to the decrease in the effective viscosity, with matching results of the film morphology from atomic force microscopy (AFM). The polymer film maintained low viscosity until a certain period of time, whereupon further annealing occurred, and the formation of holes in the film grew, which ultimately dewetted the film. The residual film decrement, growth of holes in the film, and dewetting of the polymer-confined thin film showed dependence on the effective viscosity, the strength of solvent used, and various involved interactions on the surface of substrates.

TENSILE MECHANICAL BEHAVIOR OF VACUUM CAST ATACTIC POLYSTYRENE FILMS

Studies on the Condensed Structure of Vacuum Cast Atactic Polystyrene Films

Rheology of Ultra High Molecular Weight Polystyrene

Effect of solvent concentration on development of macrovoids of PVDF phase-diversion membranes

Structure formation and characterization of PVDF hollow fiber membranes by melt-spinning and stretching method

Rheological Behavior of Carbon Black Filled Polystyrene Melts

Mechanical Properties and Structure of Poly(p-phenylenevinylene) Films Prepared by the Zone-Reaction Method

Effects of Concentration and Temperature on Mechanical Properties of Tatb/Pctfe Pbx by Molecular Dynamics Simulation

Study of Elastic Modulus and Yield Strength of Polymer Thin Films Using Atomic Force Microscopy

Preparation And Mechanical Properties Of Polystyrene Fibrous Membranes Via Electrospinning

Dynamics and Structure Formation of Confined Polymer Thin Films Supported on Solid Substrates.

Vitrification of polymer solutions as a function of solvent quality, analyzed via vapor pressures

Direct measurement and modeling of viscoelastic–viscoplastic properties of freely standing thin polystyrene films

Surface Enhanced Raman Scattering Evidence for the Existence of a Critical Concentration for Coil Shrinkage in Polystyrene Solutions

DYNAMIC RHEOLOGICAL PROPERTIES OF POLYSTYRENE/MULTI-WALLED CARBON NANOTUBES COMPOSITES

Chain entanglement and molecular dynamics of solution-cast PMMA/SMA blend films affected by hydrogen bonding between casting solvents and polymer chains

Atomistic Finite Element Simulations on the Tensile Properties of Polyhedral Oligomeric Silsesquioxane (POSS) Reinforced Polystyrene

Casting solvent effects on molecular dynamics of weak dynamic asymmetry polymer blend films via broadband dielectric spectroscopy

A SLOW RELAXATION MODE OF POLYMER CHAINS IN A SEMIDILUTE SOLUTION

Fabrication and Characterization of Polysiloxane/polyacrylate Composite Latexes with Balanced Water Vapor Permeability and Mechanical Properties: Effect of Silane Coupling Agent

Polystyrene/vinyl Ester Resin/styrene Thermoplastic Elastomer Composites: Miscibility, Morphology, and Mechanical Properties