Abstract:Micro Air Vehicles (MAVs) designed for reconnaissance and difficult to reach missions have excellent potential utility and are of interest for military and civilian applications as flight platforms for optical, acoustic, electronic and chemical sensors for operation in hazardous sites with aerial access. They are autonomous or semiautonomous airborne vehicles, measuring less than 200 meters in any dimension and weighing about 150 grams, accomplishing a useful mission at an affordable cost. Nominal performance goals include real-time imaging, navigation, and communications capabilities, a range of up to 5 kilometers, and a top speed of up to 60 kph, during missions lasting 10 mins to 1 hrs. MAVs may be regarded as six-degree-of-freedom sensor platforms that will enable a broad spectrum of small-unit and special operations. There are two prominent features of MAVs flight: (i) low operating Reynolds number (Re: 10(4)-10(5)), resulting in unfavorable aerodynamic conditions to support controlled flight, and (ii) small physical dimensions, resulting in certain favorable scaling characteristics including structural strength, reduced stall speed, and low inertia. Owing to the low Reynolds number, the aerodynamic performance of all lifting surfaces is degraded. The small scales and speeds also mean that atmospheric turbulence has a severe effect, and small thermal cycle engines that could profit from the high energy densities of fossil fuels are unavailable. It is thus difficult to obtain good flight performance.As the rapid development of microelectronics and Microelectromechanical systems (MEMS) technology, MAVs become a feasible concept. MEMS are extremely small machines in which electronic and mechanical components are combined on a single silicon chip using micromachining techniques. Development of Low Reynolds number aerodynamics design and MEMS-based autopilot system techniques are the near term object. Progresses in sensor, in control and in navigation technologies offer completely new opportunities. This paper deals with MAVs, which are the flying carriers of these advanced sensors. The developments of MAVs around the world, particularly on potential applications, wing model concepts, and onboard avionics, are reviewed at first. The bottleneck and the current situation for the integrated navigation, guidance and control system design in MAVs are then analyzed. The question of whether MEMS can help improve the performance of futuristic MAVs is also pondered.

Miniature Wireless Data Communication System for Micro Air Vehicles

Microphotography and Wireless Transmission System for Micro Aerial Vehicles

A Miniature Integrated Navigation System for Rotary-Wing Unmanned Aerial Vehicles

Research On Wireless Networks Of Data Transmission For Micro Aerial Vehicles

The Water Detection System for Mini Unmanned Aerial Vehicles

Micro Air Speedometer for Mavs

Signal Measurement and Control System in Micro Air Vehicle

Onboard Integrated Avionics And Sensors For Assisting Mavs Missions

Micro Air Vehicle: Configuration, Analysis, Fabrication, and Test

Micro Air Vehicle. Architecture and Implementation.

Design and Realization of Modular Mems-Based Attitude Measurement and Control System Based Wireless Sensor Networks

An Attitude Estimation Method for MAV Based on the Detection of Vanishing Point

On-board Communication-based Relative Localization for Collision Avoidance in Micro Air Vehicle teams

Design and Hardware-in-the-loop Simulation of MUAV's Flight Control System

Study on attitude measuring system on low-cost unmanned aerial vehicle

A Micro Wireless Attitude Determination System Based on the Extended Kalman Filter

Attitude Reference System Based On Three-Axis Magnetometers And Three-Axis Infrared Level Detectors

RF Backscatter-based State Estimation for Micro Aerial Vehicles

A Low Power and Ultra Long Range UAV Attitude Measurement System

Vision System for Mini Unmanned Aerial Vehicles Based on DSP

Guidance and implement of micro system based on GPS