Abstract:With the advancement of semiconductor manufacturing technology, thin film structures were widely used in MEMS devices. These films played critical roles in providing support, reinforcement, and insulation in MEMS devices. However, due to their microscopic dimensions, the sensitivity of their parameters and performance to thermal stress increased significantly. In this study, a Pirani gauge sample with a multilayer thin film structure was designed and fabricated. Based on this sample, finite element modeling analysis and thermal stress experiments were conducted. The finite element modeling analysis employed a combination of steady-state and transient methods to simulate the deformation and stress distribution of the device at room temperature (25 °C), low temperature (−55 °C), and high temperature (125 °C). The thermal stress test involved placing the sample in a temperature cycling chamber for temperature cycling tests. After the tests, the resonant frequency and surface deformation of the device were measured to quantitatively evaluate the impact of thermal stress on the deformation and resonant frequency parameters of the device. After the experiments, it was found that the clamped-end beams made of Pt were a stress concentration area. Additionally, the repetitive thermal load caused the cantilever beam to move cyclically in the Z direction. This movement altered the deformation of the film and the resonant frequency. The suspended film exhibited concavity, and the overall trend of the resonant frequency was downward. Over time, this could even lead to the fracture of the clamped-end beams. The variation of mechanical parameters derived from finite element simulations and experiments provided an important reference value for device design improvement and played a crucial role in enhancing the reliability of thin film devices.

Mechanical stability and sticking problem of a membrane strip structure in MEMS under Casimir forces

Theoretical Study of the Sticking of a Membrane Strip in MEMS under the Casimir Effect

Study on the design of anti-sticking structures in MEMS under different forces

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

Control of Micro Stick-Slip and Stiction in MEMS

Casimir Effect in MEMS: Materials, Geometries, and Metrologies-A Review

Oscillation Behavior of Two Mems Structures

Interfacial properties for real rough MEMS/NEMS surfaces by incorporating the electrostatic and Casimir effects-a theoretical study

Observation of Pull-in Instability in Graphene Membranes under Interfacial Forces.

Variation of MEMS Thin Film Device Parameters under the Influence of Thermal Stresses

Finite element analysis of bistable membrane and its experiment study

Adhesion-Induced Failure of the Slender Mems Structures

Regimes in the axisymmetric stiction of thin elastic plates

Role of the Casimir force in micro- and nanoelectromechanical pressure sensors

Process-induced stress and hydrogen effects on monolithic integrated BiCMOS-MEMS resonators

DETERMINATION OF MECHANICAL BEHAVIOR OF MEMS MATERIALS

Structural Optimization and Mechanical Simulation of MEMS Thin-Film Getter–Heater Unit

Investigation of the Young's Modulus and the Residual Stress of 4H-SiC Circular Membranes on 4H-SiC Substrates

On the Casimir effect in the microelectromechanical systems MEMS

A Method to Evaluate the Influence of Different Substrate on Stress Mismatch Induced Deformation in MEMS Accelerometer

Intermittent Failure Mechanism and Stabilization of Microscale Electrical Contact