Abstract:There are three difficulties in the topology optimization problem of continuum structure:1) The problem under multiple load case is not easy to be approached than that under single load case, because the former becomes a multiple objective problem on the basis of compliance objective function. 2) The problem with local constraints, such as elemental stress limit, is not easy to be solved than that with global constraints, such as displacement or frequency limits, because sensitivity analysis of the former has too expensive computation. 3) The problem with a phenomenon of ill-conditioned load, which is similar to ill-conditioned stiffness matrix in the structural analysis, is not easy to get reasonable final topological structure, because the former is difficult to consider different influences between the loads with small forces and the loads with big forces, and some of topology paths of transferring small forces may disappear during the process of iteration. To overcome the above difficulties, some measures are adopted as follows:1) Topology optimization model is established by independent continuous mapping (ICM) method. 2) Based on the von Mises criteria in theory of elastic failure, all element’ s stress constraints are transformed into a structural energy constraint, namely, a global constraint substitutes for lots of local constraints. 3) The phenomenon of the ill-conditioned load is divided into three cases: (a) Ill-condition exists between load cases, but not within each load case; (b) Ill-condition exists within some load case; (c) Ill-condition exists not only between load cases, but also within some load case. (4) A strategy based on strain energy is proposed to adopt ICM method with stress globalization, and the problems of the three cases of ill-conditioned load mentioned above are solved in term of different complementary approaches one by one. Numerical examples show that the topology path of transferring forces can be obtained more easily by substituting global strain energy constraints for local stresses constraints, and the problem of ill-conditioned load can be solved well by the weighting method which takes structural energy as weighting coefficient.

Topology Optimization for Stable Non-Linear Structures

Finite Strain Topology Optimization with Nonlinear Stability Constraints

Topology Optimization of Tensegrity Structures Considering Buckling Constraints

Isogeometric Analysis-Based Design of Post-Tensioned Concrete Beam Towards Construction-Oriented Topology Optimization

Pre- and post-buckling analysis of structures by geometrically Nonlinear Force Method

Topology-Finding Of Tensegrity Structures Considering Global Stability Condition

Topology optimization for maximizing buckling strength using a linear material model

Topology Optimization using Nonlinear Finite Element Analysis

The Path-Engulfment Method for Topology Optimization of Structures

Linear buckling topology optimization of reinforced thin-walled structures considering uncertain geometrical imperfections

Topology optimization of structural frames considering material nonlinearity and time-varying excitation

Topology optimization with linearized buckling criteria in 250 lines of Matlab

Topology optimization for prestressed cable-truss structure considering geometric nonlinearity

Level-Set-Based Topology Optimization of a Geometrically Nonlinear Structure Considering Thermo-mechanical Coupling Effect

Topology Optimization of Multiscale Structures Considering Local and Global Buckling Response

Application of Virtual Laminated Element in the Topology Optimization of Structures

A review on topology optimization of structures

Topology Optimization of Hyperelastic Structure Based on a Directly Coupled Finite Element and Element-Free Galerkin Method

Topology Optimization of Continuum Structure With Globalization of Stress Constraints

Topology Optimization of Continuum Structures Based on a New Bionics Method