Abstract:We focus on the parameter identification of doubly fed induction generator （DFIG} based wind turbine generator （WTG）. Firstly, the trajectory sensitivity analysis is used to make judgments about the identifiability of parameters. If the phases of sensitivity curves are not the same or reverse, the parameters are uniquely identifiable. By this theory, we find that the stator reactance and rotor reactance cannot be simultaneously identified, but the other parameters are uniquely identifiable. Secondly, the difficulty of identification which means the possibility of obtaining the accurate values o{ the parameters from the measurement data is analyzed. A parameter is easy to be identified if the sensitivities of both time-domain and frequency-domain are high. A parameter which has a high value only in the low frequency area of the frequency-domain sensitivity curve is relatively easy to be identified. It is found that the stator reactance, rotor reactance, and exciting reactance are easy to be identified; the stator resistance and rotor resistance are relatively easy to he identified; the inertial constant is difficult to be identified. According to the analysis of identifiability and the difficulty of identification, four key parameters including the stator resistance, stator reactance, exciting reactance, and rotor resistance are decided to be identified. Then, an ant colony optimization algorithm based identification method is designed. Finally, the correctness of the analysis and the efficiency of the identification method are validated by the simulation results obtained in Matlab/Simulink environment.

DYNAMIC PARAMETER IDENTIFICATION OF THE STEAM TURBINE-GENERATOR BY LOAD REJECTION TEST USING DYNAMOMETRY METHOD

Mechanical Parameter Identification of Synchronous Water Turbine Generator Unit

New Load Rejection Test Method for Parameter Estimation of Synchronous Generators

Parameter identification of drive system for fixed-speed wind power generation units

Analysis on the Identification of Doubly Fed Induction Generator

Model parameter identification of DFIG based on short circuit current

Identification of a composite load model with applications

Probabilistic Preassessment Method of Parameter Identification Accuracy with an Application to Identify the Drive Train Parameters of DFIG

Improvements and measurements of parameter identification for electric load

Recursive Least Square Method Based Parameter Identification of Steam Turbine Digital Electric-Hydraulic Governing System

Improvement of Load-rejection Test of Steam Turbine-generator Using Dynamometer

STUDY ON PARAMETER IDENTIFICATION FOR STEAM TURBINE DHE GOVERNING SYSTEM BASED ON GENETIC ALGORITHM

Identification method of vehicle parameters based on genetic algorithms

The Parameter Identification Method of Steam Turbine Nonlinear Servo System Based on Artificial Neural Network

Application Of Recursive Least Squares Method For Parameter Identification Of Deh Governing System

Parameter Identification of Induction Motors for Railway Traction Applications

Dynamic Model of Steam Turbine for Load Rejection

Study on parameter identification for steam turbine DEH governing system based on genetic algorithm

Parameter Identification of Steam Turbine Governing System Based on Correlation Analysis

Modeling and parameter identification of turbine-governor based on response characteristics

Study on identification method for parameter uncertain model of aero gas turbine