Abstract:The strain after rolling plays an important role in the prediction of the microstructure and properties and plate deformation permeability. So, it is necessary to establish a more accurate theoretical strain model for the rolling process. This paper studies the modeling method of the equivalent strain based on the upper bound principle and the stream function method. The rolling deformation region is divided into three zones (inlet rigid zone, plastic zone, and outlet rigid zone) according to the kinematics. The boundary conditions of adjacent deformation zones are modified according to the characteristics of each deformation zone. A near-real kinematics admissible velocity field is established by the stream function method on this basis. The geometric boundary conditions of the deformation region are obtained. The deformation power, friction power, and velocity discontinuous power are calculated according to the redefined geometric boundary conditions. On this basis, the generalized shear strain rate intensity is calculated according to the minimum energy principle. Finally, the equivalent strain model after rolling is obtained by integrating the generalized shear strain rate in time. The plate rolling experiments of AA1060 and the numerical simulations are carried out with different rolling reductions to verify the analytic model precision of the equivalent strain. The results show that the minimum and the maximum relative equivalent strain deviation between the analytic model and the experiment is 0.52% and 9.96%, respectively. The numerical calculation and experimental results show that the model can accurately calculate the strain along the plate thickness. This model can provide an important reference for the rolling process setup and the microstructure and properties prediction.

Computer aided analysis for cold roll forming thin channel section

Simulation and Analysis of UOE Pipe Production Processing by Three-Dimensional Finite Element Method

A Method for Prediction of Forming Strain for Cold Stamping Formed Head Made of S30408 Austenitic Stainless Steel

Research on the Mechanism and Processability of Roll Forming

Analysis of stress-strain in the partial heating roll forming process of high strength square hollow steel sections

Elastoplastic large deflection analysis of cold-formed members using spline finite strip method

Precise local deformation control for UHSS thin-walled component in roll forming

Testing, modelling and design of hot-rolled stainless steel channel sections under combined compression and minor-axis bending moment

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

The central strain analytical modeling and analysis for the plate rolling process

Calculation method and analysis of residual stress in the strip bending roller straightening process

Analysis of the Asymmetrical Rolling of Ultra-Thin Strips Considering Elastic Deformation of the Strips

SIMULATION OF MULTI-STAGE COLD FORMING OF A THIN-WALLED VESSEL

Modeling and analysis of deformation characteristics for the two-layered metal clad plate produced by asymmetric rolling

An investigation on longitudinal residual strains distribution of thin-walled press-braked cold formed steel sections using 3D FEM technique

Finite Element Analysis of Roll Forming using Roll Flowers with Different Bending Shapes

Finite element synthesized analysis of the forming process of spiral welded pipe

Influence of bending angle function on local thinning defects of roll-formed sheets based on segmental boundary combination optimization

Numerical and experimental analysis of edge wave defect control during TA2 circular tube cold roll forming

NUMERICAL ANALYSIS OF COLD FORMING FOR ALTERNATING ELLIPTICAL AXIS TUBE

Deformation mechanism analysis of three-roller continuous and synchronous calibration process of straightness and roundness for LSAW pipes