Abstract:Mould filling is of determining effect on the quality of castings. Numerical simulation is widely used for the study of mould filling, but the result is necessary for validation. Water analogue experiment used to be a main way for mould filling research before, but it was hard to simulate the mould filling of real castings. In this paper, a new water analogue system for real castings was established. The casting cavity was shaped by assembling transparent organic glass slices cut by laser, with each slice exactly representing the geometry of each casting section. Therefore, the shape of the mould cavity is guaranteed. The system was applied to study the filling process of a heavy steam turbine housing casting weighing 70.3 tons. Its filling process was observed and analysed. It is found that there is alternating flow in the gating system because of the height difference of the ingates. That also resulted into the uneven filling during the process. Therefore, the design was improved and it was proved to be more effective through experimental study. This water analogue method is proved to be applicable for research on the filling process of castings.

Numerical Simulation and Water Analog of Mold Filling Processes

Numerical simulation of filling flow of polymer melt in injection molding

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Numerical simulation of mold filling of casting with an improved SOLA-VOF method

Numerical Simulation of 3-D Free Surface of Mould Filling Process

Numerical Simulation of Die-Casting Mold Filling Process Based on Fractional Step Method

Water Analogue Validation of Numerical Model for Fluid Flow During Slow Shot Phase in Die Casting Process

Water Analogue Experimental Study on the Filling Process of A Steam Turbine Housing Casting

Study and Application of Mold Filling Simulation of Shaped Castings

Numerical simulation of mould filling and heat transfer of anti-gravity thin-walled casting

An Improved Mathematical Model to Simulate Mold Filling Process in High Pressure Die Casting Using CLSVOF Method and CSF Model

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Numerical Simulation of Mold Filling and Solidification of a Nickel Alloy Vane Investment Casting

Modelling and Simulation for Die Casting Mould Filling Process Using Cartesian Cut Cell Approach

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Numerical simulation and experimental verification of the initial temperature distribution of castings during mold filling process

Water Simulation Study on Filling Process with Vertical Split Gating System

An Improved Algorithm for the Simulation of Injection-Molding Filling Process

Numerical simulation of casting process for gray iron butterfly valve

Progress on Numerical Simulation of Mold Filling and Solidification Processes of Shaped Castings