Abstract:In view of the fact that the partial discharge (PD) signal energy is mainly concentrated below hundreds of megahertz, the ultra-high frequency part of the energy is weak, and the interior space of the switchgear is narrow, this paper proposes a new method for PD detection of the switchgear based on near-field detection. Firstly, based on the principle of PD, the field characteristics of the signal in the switchgear are analyzed. After that, the probe is designed with an electric small loop structure. Based on its equivalent circuit, its measurement principle and amplitude frequency characteristics are analyzed. The influence of probe size and material on amplitude frequency characteristics is obtained by using simulation software High Frequency Structure Simulator (HFSS), and the probe parameters suitable for PD detection in the switchgear are determined. Finally, the performance of the probe is measured by network analyzer, and the PD signal is tested on the simulated PD test platform. The results show that the probe works in the frequency band of 10–200 MHz and can receive PD signals containing more energy information. In the operating frequency band, the reflection coefficient of the probe port is very large, and its interference to the signal near field is particularly small. The probe also has good frequency response characteristics, and the fluctuation in the frequency band is less than 5 dB, which can obtain more accurate PD signal characteristics in subsequent processing. In addition, the probe is passive, with dimensions of 166 mm in length, 104 mm in width, and 2 mm in thickness, which is suitable for placing in the switchgear with small internal space. The results of PD receiving test show that the probe can reflect the occurrence of PD remarkably and accurately.

Partial Discharge Acoustic Emission Detector Based on Computer for Power Capacitor

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Discrimination of Three or More Partial Discharge Sources by Multi-Step Clustering of Cumulative Energy Features

Research of On-Line Detection for Power Capacitor

Pd Pattern Recognition of Power Capacitors Model Based on Combinational Neural Network

Partial Discharge Pattern Recognition Based on an Ensembled Simple Convolutional Neural Network and a Quadratic Support Vector Machine

Development and Application of DC Partial Discharge Test System

An Advanced Method for Detection of Partial Discharge in Oil-Paper Insulated Transformer Bushings and Current Transformers

Detection and Identification Technologies of Wide Band Partial Discharge

Partial discharge detection on power equipment using a magneto-resistive sensor

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

PD Signal Detection Model Based on Multiscale Simulation of EM Generation and Transmission.

The Appliance of Duffing Chaotic Detection System in Displacement Measurement of Capacitance Sensor

Study on waveform characteristics of partial discharge pulses in air

Low-Cost Online Partial Discharge Monitoring System for Power Transformers

Comparison of on-line partial discharge detection methods for HV cable joints

A Novel Hybrid Approach for Partial Discharge Signal Detection Based on Complete Ensemble Empirical Mode Decomposition with Adaptive Noise and Approximate Entropy

Identification of Partial Discharge Based on Composite Optical Detection and Transformer-Based Deep Learning Model

Application of Capacitor Sensor in PD Detection at the Three-Phase Cross-Bonding Link-System of XLPE Cable

Passive Wireless Partial Discharge Sensors with Multiple Resonances

Research on Partial Discharge Detection of Switchgear Based on Ultrasonic Signal Characteristic