Abstract:Direct time-of-flight (dToF) ranging sensors based on single-photon avalanche diodes (SPADs) have been used as a prominent depth-sensing devices. Time-to-digital converters (TDCs) and histogram builders have become the standard for dToF sensors. However, one of the main current issues is the bin width of the histogram, which limits the accuracy of depth without TDC architecture modifications. SPAD-based light detection and ranging (LiDAR) systems require new methods to overcome their inherent drawbacks for accurate 3D ranging. In this work, we report an optimal matched filter to process the raw data of the histogram to obtain high-accuracy depth. This method is performed by feeding the raw data of the histogram into the different matched filters and using the Center-of-Mass (CoM) algorithm for depth extraction. Comparing the measurement results of different matched filters, the filter with the highest depth accuracy can be obtained. Finally, we implemented a dToF system-on-chip (SoC) ranging sensor. The sensor is made of a configurable array of 16 × 16 SPADs, a 940 nm vertical-cavity surface-emitting laser (VCSEL), an integrated VCSEL driver, and an embedded microcontroller unit (MCU) core to implement the best matched filter. To achieve suitably high reliability and low cost, the above-mentioned features are all packaged into one module for ranging. The system resulted in a precision of better than 5 mm within 6 m with 80% reflectance of the target, and had a precision better than 8 mm at a distance within 4 m with 18% reflectance of the target.

A scanner-based DPSS imaging LADAR

The Staring Imaging Laser Radar Based on Plane Array Detector

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

Design and implementation of embedded signal processing system based on pulsed laser ranging technology

Design of 3D Laser Radar Based on Laser Triangulation

A Fully Solid-State Beam Scanner for FMCW LiDAR Application

A Hybrid Solid-State Beam Scanner for LiDAR Applications

Pixel Multiplexing Technique For Real-Time Three-Dimensional-Imaging Laser Detection And Ranging System Using Four Linear-Mode Avalanche Photodiodes

A Hybrid Solid-State Beam Scanner for FMCW LiDAR Application.

Solid-State Dtof LiDAR System Using an Eight-Channel Addressable, 20w/ch Transmitter, and a 128x128 SPAD Receiver with SNR-Based Pixel Binning and Resolution Upscaling.

Coded-pulse-bunch-laser-based Single-Photon Lidar for Fast Long-Distance Ranging.

A dToF Ranging Sensor with Accurate Photon Detector Measurements for LiDAR Applications

Pulsed one-dimensional scannerless LiDAR system based on linear APD array

SPADs and SiPMs Arrays for Long-Range High-Speed Light Detection and Ranging (LiDAR)

Scanning single-pixel imaging lidar

Single-photon depth imaging using a photodetector with a wire-bonding quenching resistor

Solid-state FMCW LiDAR with Two-Dimensional Spectral Scanning Using a Virtually Imaged Phased Array.

Long-range High-Speed Laser Imaging Based on VCSEL Array and MPPC Array.

PCA-based real-time single-photon 3D imaging method

High SNR signal processing system for coherent solid-state LIDAR with silicon photonic balanced photodetector array

Three-dimensional imaging laser radar with a photon-counting avalanche photodiode array and microchip laser