Abstract:Large gas turbines often utilize dual-rotor structures to improve efficiency. To facilitate manufacture and maintenance, the large rotor systems are typically constructed by connecting components made from different materials together through the bolted joint. In this work, a dynamic model of a dual-rotor system with bolted joint included in the high-pressure (HP) rotor is established based upon the finite element theory of Timoshenko beam element, as well as taking into account the bearing forces and fixed-point rubbing fault. To evaluate the influence of rubbing faults on the dynamic behavior of a dual-rotor system, this study analyzed the response characteristics of the rotor under the cases of the LP rotor and the HP rotor subjected to the rubbing fault, respectively. In order to further reveal the effect of bolted joint structure on the system response while rubbing fault occurs, piecewise linear bending stiffness is also considered in this study. The nonlinear vibration responses of the bolted joint dual rotor-bearing system are studied through numerical simulation. Effect of rotor–stator contact stiffness and the occurrence of rubbing faults at the low-pressure (LP) rotor and the HP rotor are investigated through frequency-amplitude curves, waterfall diagrams, time-domain responses, and bending stiffness of the bolted joint. The results indicate that the presence of rubbing faults, whether occurring at the LP rotor or the HP rotor, leads to a decrease in the critical speed. Furthermore, under a rubbing fault, the bending stiffness of the bolted joint enters the stiffness softening region earlier and exhibits a wider range, which is exacerbated with increased contact stiffness. This phenomenon is considered one of the main causes of system response instability. Finally, the experimental studies are carried out on a bolted joint dual-rotor test rig to validate the numerical simulation results.

Nonlinear Dynamics of Rotor Rubbing against Rotor-Stator on Flexible Supports

Nonlinear Dynamics of a Rub-Impact Rotor Supported by Oil Film Bearings with an Elastic Stator

Experimental Investigation of Rotor Rubbing Faults

Rub Fault Diagnostics by Dynamic Characteristics Analysis of a Multi-Disk Rotor System

Vibration Analysis of a Nonlinear Rotor-Bearing-seal System

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

Chaotic behavior of a rub rotor model

Stability of a Rub-Impact Rotor System

Lubrication and stability analysis of nonlinear rotor-bearing system

Nonlinear dynamics of a rotor–stator system with contacts

Bifurcation Behavior of a Flexible Rotor Supported on Nonlinear Squeeze Film Dampers Without Centralized Springs

Experimental observation of nonlinear vibrations in a rub-impact rotor system

The Partial and Full Rubbing of a Flywheel Rotor–bearing–stop System

Dynamic Characteristics of Rotor System and Rub-Impact Fault Feature Research Based on Casing Acceleration

Stability and Bifurcation of Rotor-Coupling System Applied by Nonlinear Oil Film Forces

On the Bifurcation and Stability of Periodic Motion of the Rotor-Bearing System with Rub-Impact and Oil Whirl

Rub-impact dynamic analysis of a dual-rotor system with bolted joint structure: Theoretical and experimental investigations

Dynamic analysis of slant cracked rotor system considering nonlinear oil film force

NONLINEAR DYNAMICS OF ROTOR DROP ON ROLLING ELEMENT BACKUP BEARINGS AFTER ACTIVE MAGNETIC BEARINGS FAILURE

Nonlinear Vibration of Rotor Rubbing Stator Caused by Initial Perturbation

Periodic, quasi-periodic and chaotic vibrations of a rub-impact rotor system supported on oil film bearings