Abstract:The performance of the inverse class-E power amplifier at sub-nominal condition for any duty ratio is investigated in this paper. Comparing with the inverse class-E power amplifier at nominal condition, which demands both zero-current-switching (ZCS) and zero-current-derivative-switching (ZCDS) conditions simultaneously, the presented inverse class-E power amplifier at sub-nominal condition is only restricted by the ZCS condition. The proposed power amplifier increases two design parameters because the ZCDS condition limitation is cancelled and the duty ratio can be arbitrarily set. The analytical results demonstrate that the theoretical drain efficiency is still 100% and that all the circuit elements can be adjusted by the two released parameters. Furthermore, the influences of the transistor's parasitic switch-on resistor and output capacitor are investigated and a simulation example is given to verify the proposed design methodology's accuracy. Although it is not sufficiently tolerant of the elements mismatches and the transistor's parasitic capacitor in practical design, the inverse class-E power amplifier at sub-nominal condition is still one of the promising candidates for high-efficiency power amplifier design if the two drawbacks are appropriately averted.

An improved push-pull Class-E RF tuned power amplifier with low maximum transistor current

A Class-F Based Power Amplifier with Optimized Efficiency in Triple-Band

Compact 50-62 GHz Current-Reused Low-Noise Amplifier with Gate-Drain Transformer Feedback

A Broadband High-Efficiency Quasi Class E Internally-matched GaN Power Amplifier with a Compact Band-Pass Output Matching Structure

A 30-680-mhz GaAs Phemt Power Amplifier with Guanella-type Transformers Integrated on a Flexible Printed Circuit Board

High efficiency class-E RF power amplifier for wireless power transfer system

Maximum Optimum Load Of Class-E Rf Tuned Power Amplifier In Low Voltage Design

A Two-Stage Push-Pull Power Amplifier with Electro-Thermal Effects Study in 130 nm SOI CMOS for IEEE 802.11ac Applications

An Improved Method Of Power Control With Cmos Class-E Power Amplifiers

High-efficiency Class E/F-3 Power Amplifiers with Extended Maximum Operating Frequency

Output Power Improvement by Impedance Matching Networks for a Class E Power Amplifier Driven Wireless Power Transfer Systems

'New' Solutions of Class-E Power Amplifier with Finite Dc Feed Inductor at Any Duty Ratio

A 600W broadband doherty power amplifier with improved linearity for wireless communication system

The Closed-Loop Design of Inverse Class-E Power Amplifier for Wireless Energy Transmission System

High Efficiency Triple-Stacked Class-E Power Amplifier with Novel Dynamic Biasing Network

High-efficiency Class-F<sup>&#x2212;1</sup> Power Amplifier Design with Input Harmonic Manipulation

Investigation of Inverse Class-E Power Amplifier at Sub-Nominal Condition for Any Duty Ratio

A Class-F RF Power Amplifier with Lmproved LC Matching Circuit

A study on GaN-based high-efficiency class E power amplifier circuits at medium-low frequencies

A 400M-510MHz On-Chip Transformer-Based RF Power Amplifier with 22.5dBm Output Power and 48% PAE.

A 2.6 Ghz Class-E Power Amplifier Design