Abstract:Presented in this invited lecture are systematic investigation results of the heat transfer and pressure drop characteristics for three classes of heat transfer enhancement surfaces. These are plate arrays with an oblique angle to the flow direction, plate fin-and-tube surfaces and the circular tubes with wave-like longitudinal fins and a blocked-center. For the plate arrays, it is found that from the identical pumping power and identical pressure drop constraints the best oblique angle is around 30 degrees; the non-uniformity in the successive plate length may enhance heat transfer by about 20 %, and at the very low Reynolds number region, both heat transfer and friction factor exhibit characteristics of flow and heat transfer in a straight duct. General correlations of heat transfer and friction factor are presented for four types of plate fin-and-tube exchanger surfaces, these are plain plate fin, slotted fin, plate fin with triangular cross section and plate fin with sinusoidal cross section. Results show that heat transfer is a weak function of both fin spacing and tube row number, while the friction factor is nearly independent of the tube row number. Experiments also show that the interwall cylinder between the plates can enhance the heat transfer and promote the transition from laminar to turbulent flow. For the circular tube with wave-like longitudinal fins and a blocked center-part, a general heat transfer correlation obtained from six tubes with different wave numbers is provided. Because of the small hydraulic diameter, and the extended surface, the tube side heat transfer of air can be greatly enhanced. Moreover, the blockage of the center part may further enhance the heat transfer..

Performance Evaluation Of Forced Convective Heat Transfer Across Plate Arrays

Heat Transfer and Fluid Flow Characteristics of Plate-Array Aligned at Angles to the Flow Direction

Numerical Simulation on Heat Transfer and Fluid Flow Characteristics of Arrays with Nonuniform Plate Length Positioned Obliquely to the Flow Direction

An Experimental-Study on Heat Mass-Transfer and Pressure-Drop Characteristics for Arrays of Nonuniform Plate Length Positioned Obliquely to the Flow Direction

Some Enhancement Studies For Laminar And Tuebulent Heat Transfer Of Air In Tubes And Across Plates

Numerical Simulation Of Heat Transfer Performance Of Slotted Fin Surface

Numerical Simulation of Heat Transfer at an Array of Co-Planar Slat-Like Surfaces Oriented Normal to A Forced Convection Flow

Experimental Study on Heat Transfer and Pressure Drop Characteristics of Four Types of Plate Fin-and-tube Heat Exchanger Surfaces

Heat Transfer at an Array of Co-Planar Slat-Like Surfaces Oriented Normal to a Forced Convection Flow

Experimental study on heat transfer and pressure drop characteristics in the developing region for arrays of obliquely positioned plates of nonuniform length

On the Heat Transfer Enhancement of Plate Fin Heat Exchanger

Experimental Investigation of Mixed Convection in Rectangular Channel with Attached Flat Heated Plate

Modeling Natural Convection Heat Transfer from Perforated Plates

Numerical Investigation of Impingement Heat Transfer on A Flat and Square Pin-Fin Roughened Plates

Numerical study of simultaneous natural convection heat transfer from both surfaces of a uniformly heated thin plate with arbitrary inclination

Investigation to Conjugated Natural Convection Heat Transfer from a Vertical Plate with Discrete Heat Sources

Comparative Study Of Impinging Jet Array Heat Transfer On A Flat Plate Cooled By Superheated Steam And Air

Experimental Investigation on Heat Transfer and Flow Friction Characteristics in Three Types of Plate Fin-and-Tube Heat Exchangers

Natural Convection to Air from an Array of Vertical Parallel Plates with Discrete and Protruding Heat Sources

Experimental and Numerical Study on Heat Transfer and Fluid Flow Characteristics of Slotted Fin and Tube Heat Transfer Surfaces

Thermo-Hydraulic Performance Evaluation, Field Synergy, and Entransy Dissipation Analysis for Hexagon-Like and Circular-Like Pin Finned Tube Bundles