Abstract:Since the 1960s, it has been a common practice worldwide to pursue a homogeneous distribution of reinforcements within a matrix material, discontinuous metal matrix composites (DMMCs) in particular. Taking an overview of the worldwide activities in DMMC research, despite many favourable attributes such as improved specific strength, stiffness and superior wear resistance, DMMCs with a homogeneous microstructure tend to exhibit a very low room temperature damage tolerance even with a highly ductile matrix material such as aluminium. In this review, a range of uniquely multi-scale hierarchical structures have been successfully designed and fabricated by tailoring reinforcement distribution for DMMCs in order to obtain superior performance. A variety of specific microstructures that were developed in Al, Mg, Cu, Fe, Co and TiAl matrices indicate that there must be adequate plastic regions among the reinforcements to blunt or deflect cracks if one wants to toughen DMMCs. Following this path, aided by theoretical analyses, the most recent success is the design and fabrication of a network distribution of in situ reinforcing TiB whiskers (TiBw) in titanium matrix composites (TMCs), where a tailored three-dimensional (3D) quasi-continuous network microstructure displays significant improvements in mechanical properties. This resolves the brittleness surrounding TMCs fabricated by powder metallurgy. It is the large reinforcement-lean regions that remarkably improve the composite’s ductility by bearing strain, blunting the crack and decreasing the crack-propagation rate. The fracture, strengthening and toughening mechanisms are comprehensively elucidated in order to further understand the advantages of such an inhomogeneous microstructure, and to justify the development of novel techniques to produce such inhomogeneous microstructures. This approach opens up a new horizon of research and applications of DMMCs and can be easily extended to general multi-phase composites with enhanced physical and mechanical properties.

Micro-structure Parameter Optimization Design of Short-fiber/whisker Reinforced Composite

Reinforcement mechanisms and optimum design of laminated ceramic composites

Microstructurally inhomogeneous composites: Is a homogeneous reinforcement distribution optimal?

A Novel Method for Through-Thickness Reinforcement of Laminated Composites Using Discrete Micro-Polarization-induced Fiber Injection (DMFI) Approach

A Novel Discrete–continuous Material Orientation Optimization Model for Stiffness-Based Concurrent Design of Fiber Composite

Optimization of Micro Structures to Elastoplastic Properties in Fiber Reinforced Composite Materials

Parametric Study and Optimization of 2D Woven C/C-SiC Composite

Structural Topology Design Optimization of Fiber-Reinforced Composite Frames with Fundamental Frequency Constraints

Investigation on the Effects of Microstructure on Machining Unidirectional Carbon Fiber Reinforced Polymer Composites with a Modified Force Model

Bioinspired Microstructure Design Simultaneously Enhances Strain-Rate Stiffening and Toughening of Composites

Study of key technologies on whisker-reinforced ceramic matrix composites (Part III): design of in-situ fibrous monolithic structure and laminated structure

MICROSTRUCTURE DESIGN OPTIMIZATION OF MATERIALS WITH SPECIFIC ELASTIC PROPERTIES

Hot compressive deformation behavior of an aluminum matrix composite reinforced with whiskers

Optimization of damping properties of staggered composites through microstructure design

Optimization design for 3D-braided composite structure under thermo-mechanical load

A Universal Shear-Lag Model for Accurate Assessment of Whisker Load-Transfer Strengthening in Metal Matrix Composites

FUNDAMENTAL FREQUENCY MAXIMIZATION DESIGN FOR CONTINUOUS FIBER-REINFORCED COMPOSITE STRUCTURES

Profound Strengthening and Toughening Effect of Reinforcement Aspect Ratio in Composite with Network Architecture

Microscopic Reinforcement for Cement Based Composite Materials

Strain Rate Dependent Deformation of a Polymer Matrix Composite with Different Microstructures Subjected to Off-Axis Loading

Layout design and mechanical behavior of 3D printed intralayer hybrid continuous carbon/glass fiber composites