Abstract:Fault identification and diagnosis of steam turbine generator unit is very important for safely and economically operation of a power plant. Currently, on-line monitoring is already widely utilized for. alarming and recording in steam turbine. However, large amount of on-line monitoring data is not fully utilized to realize on-line fault diagnosis and identification, especially multi-concurrent fault. In the present study, model-based method was used for on-line vibrational fault identification and diagnosis based on rotordynamics. A 660MW supercritical steam turbine rotor system was modeled using FEM. Single faults, such as mass unbalance, local shaft bow and transverse crack, and multi-concurrent faults were simulated. Fault-induced changes of equivalent loads were analyzed to figure out fault type, location and severity. For model-based method, fault diagnosis accuracy is influenced by the model accuracy and signal noise. Model sensitivity was studied in this research by comparing the influence of different model error and SNR (Signal to Noise Ratio). It was used to evaluate the degree of confidence of the diagnosis result. The smaller was the model sensitivity, the higher was the degree of confidence. Based on this research, model-based method was utilized to analyze real vibration signals extracted from the historical data of this unit. Fault identification result was an effective basis for conditioned based maintenance.

A Study of the Method for Locating the Friction and Clearance in a Steam Turbine Governing System

Detection Method for Jam Fault in Manipulative Mechanism of Steam Turbine Regulating System

Analysis and Diagnosis on Internal Leakage in Electro-Hydraulic Quick-Control Regulating System of Steam Turbine

Research on Boundary Conditions of T Steam Turbine Blade by Finite Element Model Analysis

Research on New Type of Fast-Opening Mechanism in Steam Turbine Regulating System and Optimization of Operation Tactic

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

Performance Monitoring and Fault Diagnosis about Flow Passage of Turbines in Nuclear Power Plant

Suppression of Low-frequency Vibration Fault

Investigating the vibration response and modulation mechanism for health monitoring of wind turbine planetary gearboxes using a tribodynamics-based analytical model

Study of the Phase Resonance Phenomenon in Francis Turbine

STUDY ON METHODS OF VIBRATION FAULT DIAGNOSIS BASED ON TIME-FREQUENCE CONTOUR MAP FOR TURBINE GENERATOR UNIT

Fractal Geometry and Its Applications in Vibration Failure Symptom Abstraction of the Steam Turbine

Low-frequency Vibration In High-pressure Turbines Rotor

Investigation on the Unsteady Pressure Fluctuation Characteristic in the Blade Tip Seal of Steam Turbine Based on Spectrum

Dynamics of Slant Cracked Rotor for a Steam Turbine Generator System

Strength and Vibration Analysis of a Francis Turbine

Research Overview and Prospects of Fault Diagnosis Technique of Steam Turbine Flow Passage

Identification Of Multi-Concurrent Fault In A Steam Turbine Rotor System Using Model-Based Method

The Analysis of Differential Pressure under the Accident Condition of Steam Turbine

Dynamic Analysis of a Francis Turbine Based on the Fluid-Structure Interaction Theorem

Numerical simulation of the relationship between steam flow excitation characteristics and coverage on the governing stage of marine steam turbine