Abstract:This paper studies a dual-wavelength single-frequency Er-doped fiber laser based on ring cavity, the output wavelengths are 1 570 nm and 1 548 nm. The laser combines Fabry-Perot (FP) filter and Fiber Bragg Grating (IFBG) to achieve wavelength selection and preliminary stabilization. And two unpumped Er-doped fibers act as saturable absorbers to realize linewidth narrowing effect. The Laser Diode (L.D) used has a maximum drive current of 700 mA, which corresponds to a maximum pumping power of 450 mW and 500 mW. When the pump power of LD1 is up to 58 mW and the diver current of LD2 is up to 138 mW, the fiber laser gets dual-wavelength output. The output power of the 1 570 nm and 1 548 nm laser generated at this time are 4.2 mW and 10.1 mW respectively. Then the pump power of LD1 and LD2 are adjusted to 104 mW and 83 mW respectively, and the output laser characteristics were studied under this condition. The output power in 1 570 nm is 10.3 mW, the Optical Signal to Noise Ratio (OSNR) is 58 dB. The output power in 1 548 nm is 4.7 mW, and the OSNR is 55 dB. It shows that the output laser has a relatively high-quality factor and high slope efficiency. Then the stability of the output laser is studied. In order to measure the stability of the output laser of the dual-wavelength single-frequency laser, data collection is started half an hour after the laser is turned on in the experiment. Every 10 min, the spectrum is collected and the output power is recorded. The power fluctuations of the laser output in 1 370 run and 1 548 nor are 0.01 dBm and 0.02 dBm, respectively, and the wavelength drifts of the output laser are both less than 0.01 nm. The result shows that the fiber laser can avoid the mutual interference between the two wavelengths. The output laser has good power stability and wavelength stability. The laser linewidth is the parameter of most concern fora single-frequency fiber laser. In this experiment, the linewidths of the output laser are measured by the delay non zero self heterodyne method based on the Mach-Zehnder interferometer and fitted with the Lorentz curve. And it can be calculated from the 20 dB bandwidth of the Lorentz curve. The linewidths of output laser in 1 570 urn and 1 548 urn measured are about 230.2 Hz and 223.6 Hz. The narrow linewidth indicates that the output laser has good single frequency performance, and it is also an important basis for the wide application of this laser. In this study, the idea of multiplexing Fiber Fabry-Perot (FFP) filter is proposed, and the two sub-cavities do not interfere with each other by introducing circulator at both ends of FFP. It also does riot introduce any expensive polarization devices, and does riot need to use a polarization controller to control the polarization state of the tight in the cavity. So it greatly reduces the difficulty of experimental operation and cost of the experiment. The fiber laser has a simple structure, good stability and the output laser has a narrow linewidth. It provides a technical method for realizing dual-wavelength single frequency laser output, and it can also be used as a seed tight source in high precision measurement field.

High-Stability and Broad-Band Erbium-Doped Superfluorescent Fiber Source

Theoretical Analysis of Erbium-doped Superfluorescent Fiber Source in Double-pass Backward Configuration

A New Three-stage Structure for a High-performance L-band Erbium-doped Superfluorescent Fiber Source

Forward-pumping Dual-stage Double-pass Broadband Erbium-doped Fiber Source

High-Stability Er-Doped Superfluorescent Fiber Source Incorporating Photonic Bandgap Fiber

Characteristic Analysis of Praseodymium Doped Superfluorescent Fluoride Fiber Source Operating at 1.3 Μm

301 W Narrow-Linewidth In-Band Pumped Er:Yb Co-Doped Fiber Amplifier at 1585 Nm and Related Modeling for Dynamics Study and Optimization

Toward an ultra-broadband emission source based on the bismuth and erbium co-doped optical fiber and a single 830nm laser diode pump.

Studies of Central Wavelength of High-Power All-Fiber Superfluorescent Sources with Yb-Doped Double-Clad Fibers

The Numerical Analyses for Erbium-Doped Superfluorescent Fiber Sources

High-power single-stage thulium-doped superfluorescent fiber source

Er3+/Yb3+ Co-Doped Fluorotellurite Glass Fiber with Broadband Luminescence

Stable Multi-Wavelength Erbium-Doped Fiber Laser by Using Dispersion-Shifted Fiber

Improved Fluorescence and Gain Characteristics of Er-Doped Optical Fiber with PbS Nanomaterials Co-Doping

Theoretical and Experimental Investigations on Erbium-Doped Fiber Amplifiers

Time-dependent Characteristics of Pulsed Er-doped Superfluorescent Fiber Amplifiers

Tunable erbium-doped-fiber laser based on the Double-Superimposed Fiber Bragg Gratings

A Superfluorescent Fiber Source with High Mean Wavelength Stability

1 570 nm and 1 548 nm Dual-wavelength Single-frequency Er-doped Fiber Laser

THE NUMERICAL MODELING OF ERBIUM-DOPED SUPERFLUORESCENT FIBER SOURCE

145 W single-frequency fiber laser at 1607 nm with the seed and MOPA configuration