Abstract:The rectilinear motion of a vibration-driven mechanical system composed of two identical modules connected by an elastic element is considered in this paper. Each module consists of a main body and an internal mass that can move inside the main body. Anisotropic linear resistance is assumed to act between each module and the resistant medium. The motion of the system is excited by two acceleration-controlled masses inside the respective main bodies. The primary resonance situation that the excitation frequency is close to the natural frequency of the system is considered, and the steady-state motion of the system as a whole is mainly investigated. Both the internal excitation force and the external resistance force contain non-smooth factors and are assumed to be small quantities of the same order when compared with the maximum value of the force developed in the elastic element during the motion. With this assumption, method of averaging can be employed and an approximate value of the average steady-state velocity of the entire system is derived through a set of algebraic equations. The analytical results show that the magnitude of the average steady-state velocity can be controlled by varying the time shift between the excitations in the modules. The optimal value of the time shift that corresponds to the maximal average steady-state velocity exists and is unchanging with the external coefficients of resistance. For a system with specific parameters, numerical simulations are carried out to verify the correctness of the analytical results. The optimal value of the time shift is numerically obtained, and the optimal situation is studied to show the advantages of the control.

Low Speed Motion Stability Analysis of Mechanical System Based on Internal Feedback

Dynamic analysis on linear motor drive unit based on multi-modes motion

Coupled Vibration Mode Analysis of a Ball Screw Drive System

Analysis on Steady-State Vibration Induced by Backlash in Machine Tool Rotary Table

Nonlinear dynamics investigation of a multi-axis drive system due to the kinematic joints

Dynamic analysis and modeling of ball screw feed system with a localized defect on the support bearing

Closed-Loop Stability Analysis Of A Flexible Robot Arm Using Feedback Control

Self-Tuning Controller Design for Motion Control Systems

Dynamic Modeling and Analysis of the High-Speed Ball Screw Feed System

Analysis of Dynamic Modeling and Control of Parallel Mechanism

Nonlinear dynamic modeling and vibration analysis of whole machine tool

Dynamic Analysis on Rotor System Supported by Active Electromagnetic Bearings

Robust Internal Model Control with Feedforward Controller for a High-Speed Motion Platform

Dynamic Characteristics of Mechanical System in Linear Motor Feed System

Nonlinear Control for a Class of Underactuated Mechanical Systems

Controlled Motion of a Two-Module Vibration-Driven System Induced by Internal Acceleration-Controlled Masses

Hybrid dynamic modeling of a high-speed ball-screw drive system

Research on the Self-Excitation and Identification Method of Modal Parameter of Feed System of Numerical Control Machine Tool

Dynamic reliability analysis of mechanical system with wear and vibration failure modes

Dynamic Analysis on Rotor System Supported by Active Magnetic Bearings based on Sliding Mode Control

Vibration Analysis of Highl-Speed Ball-Screw Drive in Machine Tool Feed System.