Abstract:The cutterhead driving system of tunnel machine is over-actuated by redundant driving chains with inevitable load and parameter deviations. These deviations were rarely considered, and the researches on multi-motors synchronization and gear dynamics were usually isolated. In this paper, a novel electromechanical coupled model of the whole cutterhead driving system is established by connecting the vector-controlled motors via gear meshing system. Force transmissions between all coupled elements are investigated by analyzing rotational and translational dynamics, and the time-varying meshing stiffness and nonlinear backlash of both parallel pinions driving and multi-stage planetary reducer are considered. The phase and frequency features of meshing dynamics are also investigated. Comparative simulations are carried out with load and parameter deviations between multi-chains under two control structures, speed parallel control and torque master-slave control; some practical control principles are also concluded. The simulation results are verified and applied on a Φ2.5-m test rig. The consistent results indicate that, the meshing dynamics have the frequency components of carrier revolution and the meshing frequencies of both current planet and endmost pinion. Torque master-slave control could realize torque synchronization against all the adverse deviations while speed parallel control fails, and the vibration could be significantly reduced with lower rigidity in speed control.

Dynamic analysis on linear motor drive unit based on multi-modes motion

Dynamic modeling and vibration response analysis of high speed motorized spindle

Dynamic Characteristics of the Over-Actuated Cutterhead Driving System in Tunnel Machine

Modeling and Simulation of Non-Linear Dynamic Process of the Induction Motor System with Fluctuating Potential Loads

Nonlinear dynamics investigation of a multi-axis drive system due to the kinematic joints

Analytical modeling of stator vibration for surface mount permanent magnet brushless motors

Dynamic Analysis of Support System of Permanent Magnet Traction Motors for High-Speed Trains

Dynamic Modelling Using Screw Theory And Nonlinear Sliding Mode Control Of Serial Robot

Modeling, Identification, and Adaptive Robust Motion Control of Voice-Coil Motor Driven Stages

Parameters Identification of Dynamic Characteristics of Sliding Joint Surface of Linear Motor Feed Drive System

Hybrid dynamic modeling of a high-speed ball-screw drive system

Dynamic Modeling and Analysis of Bundled Linear Ultrasonic Motors with Non-Ideal Driving

Dynamic Modeling Approach in View of Vector Control and Behavior Analysis of a Multi-Three-Phase Star Permanent Magnet Synchronous Motor Drive

Dynamic analysis of traction motor in a locomotive considering surface waviness on races of a motor bearing

Dynamic characteristics analysis of gear system with time-varying torque of motor and load based on motor control strategy

Dynamic compensation suppression and fluctuation modeling of counterweight disturbance for vertical layout linear motor

Dynamic modelling of traction motor bearings in locomotive-track spatially coupled dynamics system

Coupling Mechanism Analysis and Dynamic Modeling for Lorentz Motor Motion Control

A Multi-Point Contact Model Considering Rough Surface for Linear Ultrasonic Motors: Validation and Simulation

Dynamic modeling and analysis of multi-link mechanism considering lubrication clearance and flexible components

Modal synthesis dynamic modeling and analysis for an automotive drive axle system