Abstract:Abstract This paper presents 3D Fabry–Pérot (FP) cavities fabricated directly onto cleaved ends of low-loss optical fibers by a two-photon polymerization (2PP) process. This fabrication technique is quick, simple, and inexpensive compared to planar microfabrication processes, which enables rapid prototyping and the ability to adapt to new requirements. These devices also utilize true 3D design freedom, facilitating the realization of microscale optical elements with challenging geometries. Three different device types were fabricated and evaluated: an unreleased single-cavity device, a released dual-cavity device, and a released hemispherical mirror dual-cavity device. Each iteration improved the quality of the FP cavity’s reflection spectrum. The unreleased device demonstrated an extinction ratio around 1.90, the released device achieved 61, and the hemispherical device achieved 253, providing a strong signal to observe changes in the free spectral range of the device’s reflection response. The reflectance of the photopolymer was also estimated to be between 0.2 and 0.3 over the spectrum of interest. The dual-cavity devices include both an open cavity, which can interact with an interstitial medium, and a second solid cavity, which provides a static reference reflection. The hemispherical dual-cavity device further improves the quality of the reflection signal with a more consistent resonance, and reduced sensitivity to misalignment. These advanced features, which are very challenging to realize with traditional planar microfabrication techniques, are fabricated in a single patterning step. The usability of these FP cavities as thermal radiation sensors with excellent linear response and sensitivity over a broad range of temperature is reported. The 3D structuring capability the 2PP process has enabled the creation of a suspended FP heat sensor that exhibited linear response over the temperature range of 20 oC –120 oC; temperature sensitivity of ∼50 pm oC −1 at around 1550 nm wavelength; and sensitivity improvement of better than 9x of the solidly-mounted sensors.

Optic Fiber Fabry-Perot Interferometer Made Through Ionic Self-Assembly Approach

Tunable Fabry-Perot Interferometer from Ferroelectric Polymer Based on Surface Energy Modification

Mach-Zehnder Interferometers Assembled with Optical Microfibers or Nanofibers

Optical Interleaver Based on Multicavity Fabry-Perot Thin Film Filter

Sensitivity-enhanced Optical Sensor Based on Multilayer Coated Fabry–Pérot Interferometer

Amorphous thin films for mechanically flexible, multimaterial integrated photonics

Three-dimensional Fabry–Pérot cavities sculpted on fiber tips using a multiphoton polymerization process

High pressure-sensitive and stable fiber Fabry-Perot interferometer with nano-diaphragm assembled by H-O catalysis bonding

Assembly Photonic Crystal Arrays on the Facet of Optical Fibers and Its Applications

Polymer Microbubble-Based Fabry–Perot Fiber Interferometer and Sensing Applications

Optical Fiber Internal-Mirror-based Fiber In-Line Mach-Zehnder Interferometer

Fiber Polarized-Light Interferometer for Precise Measurement

Optical Microfibers Integrated with Evanescent Field Triggered Self-Growing Polymer Nanofilms.

In-line fiber optic optofluidic sensor based on a fully open Fabry-Perot interferometer

A Self-Assembled Fiber Mach–Zehnder Interferometer Based on Liquid Crystals

Advanced fabrication of polymer waveguide interferometric sensor utilizing interconnected holey fibers

Mach-Zehnder Interferometer and Bragg Grating combined Fiber Device by Femtosecond Laser Inscription

Spheroidal Fabry-Perot microcavities in optical fibers for high-sensitivity sensing

An IFPI Temperature Sensor Fabricated in an Unstriped Optical Fiber with Self-Strain-Compensation Function.

A Capillary-Induced Self-Assembly Method under External Constraint for Fabrication of High-Aspect-ratio and Square Array of Optical Fibers