Abstract:The integrated gate commutated thyristors (IGCTs) are commonly used for construction of high voltage three-level PWM controlled voltage source converter/inverters. When the output voltage is greater than the maximum rated voltage, IGCTs are connected in series. To ensure the safe and reliable operation of the converter/inverters, special measures are required to equalize the voltages across the IGCTs connected in series. An effective method for balancing voltages is to use resistors for static voltage balancing and RC snubber circuits for dynamic voltage balancing. However, most of the previous research work reported in the literature focused on the dynamic circuit design for converters of the BUCK topology. Trade off is made only between the performance of dynamic voltage balancing and the turn-on loss without any consideration of di/dt endurance and any procedural steps, which makes the design procedure not suitable for converters of the three-level topology. Based on a functional model of IGCTs, this paper presents a procedure for optimum design of the dynamic voltage balancing circuit for a 6 kV/1250 kW inverter. The specific transient processes in the three-level topology with dynamic snubber circuit are simulated and the mechanisms are analyzed, which is absent in the previous work.

Modeling for General Snubber Circuits and the Reason for Voltage Unbalance between the Inner and Outer Devices in Three Level IGBT Converters

Simplified Modeling of Power Electronic Interfaced Load Considering Harmonics

Study on Neutral-Point Voltage Balance of 3-Level NPC Inverter in 3-Phase 4-Wire System

Voltage-Balanced Behavioral Model Considering Carrier Extraction Effect for Series-Connected Trench Gate FS-IGBTs

Common Mode Voltage Reduction and Neutral-Point Voltage Balance for Quasi-Z-Source Three-Level Neutral-Point-Clamped Inverters

A Fo-Adrc Based Neutral-Point Potential Balancing For Three-Level Inverter

A Coupled 3D FEM-Distribute Circuit Model for Numerical Analysis of Small Time Scale Transients of an IGBT based Inverter

Modeling of Busbars in High Power Neutral Point Clamped Three-Level Inverters

Modeling and Triple-Loop Control of ZVS Grid-Connected DC/AC Converters for Three-Phase Balanced Microinverter Application

MODELING AND DESIGN OF THREE-PHASE INVERTER WITH RECTIFIER LOAD

A Proposed Neutral-Point Voltage Balancing Method for Three-Phase Three-Level T-type Inverter under Non-Unity Power Factor

Dynamic Phasor Model of Line Commutated Converter Under Unbalanced Conditions

Impedance Modelling and Stability Analysis of Grid Side Converter under Unbalanced Weak Grid by Harmonic Transfer Matrix

Modeling and Research of Three-Phase Inverter Powering Nonlinear Load

A Neutral-Point Potential Balancing Control Method with Third Harmonic Injected Pulse Width Modulation for Three-Level Converters

Dynamic Equivalent Circuit Design in Three-level High Voltage Inverters Based On Functional Model of IGCT

Compensation-Voltage-Injection-Based Neutral-Point Voltage Fluctuation Suppression Method for NPC Converters

A New Neutral-point Potential Balancing Control Method for Three-level Inverters

An Improved Mcmurry Snubber for Three-Level Npcigbt Converter

A Specific Analysis Model of Three-Level Npc Inverter Fed Adjustable Speed Drive System with High Accuracy

Modeling and Defect Analysis of Transformer-Less Multilevel Back-to-Back Cascaded H-Bridge Converter