Abstract:The objective of this study is to demonstrate the feasibility that a fully-coupled nonlinear piezo(electric)-thermoelastic/ control structronic systems can be represented by a single micro-electronic chip. This non-volatile chip is a poTable.11e miniature hardware that serves as a design standard for future calibration and diagnosis of the original "large-scale" structronic system and it can be used anywhere after any catastrophic disruption in extreme hostile environments. Distributed control of a nonlinear structronic beam system (i.e., an elastic beam laminated with distributed sensors/actuators and coupled with control electronics) subjected to mechanical and temperature excitations has been investigated recently. This study is to design an integrated electronic circuit chip encompassing the complete piezothermoelastic and control behavior of the nonlinear structronic beam system. The fully coupled nonlinear beam equations are first discretized into a number of "elements" and each element can be implemented by an active circuit block including operational amplifiers, resistors, capacitors, and other nonlinear multipliers. Signals from the integrated circuit chip of the coupled nonlinear piezothermoelastic beam system are favorably compared with analytical solutions.

Design of a 128dB numerical control attenuator

A DC-28-GHz 7-Bit High-Accuracy Digital-Step Attenuator in 55-nm CMOS

Design of a Low-Insertion-phase-shift MMIC Attenuator Integrated with a Serial-to-parallel Converter

A Novel Ultra Broadband 8-45 GHz 4-Bit GaAs Pseudomorphic High Electron Mobility Transistors (phemt) Monolithic Digital Attenuator Used for Gain Control of Transceivers

A DC-32GHz 7-Bit Passive Attenuator with Capacitive Compensation Bandwidth Extension Technique in 55 Nm CMOS

An Ultra Broadband DC-40GHz 4-Bit GaAs Phemt MMIC Digital Attenuator

A Design for a Digitalized Variable Optical Attenuator

A DC-<i>Ka</i>-Band 7-Bit Passive Attenuator With Capacitive-Compensation-Based Bandwidth Extension Technique in 55-nm CMOS

Digitally Controlled Programmable High‐speed Variable Optical Attenuator

Micromechanical Variable Optical Attenuator Based on EDM Micromachining

Chip Design For Coupled Nonlinear Structronic Thermo-Electro-Elastic/Control Systems

Research and application of digital potentiometer

Ultra-wideband amplitude-phase compensation digital switch attenuator circuit

Research on the Inherent Nonlinearity Calibration of the Potentiometer of a Miniature Linear Series Elastic Actuator

Design and evaluation of a novel dual-channel complementary potentiometer for rotation measurement

Flap/slat control lever signal algorithm based on potentiometer for civil aircraft

A Novel Variable Optical Attenuator Based on Micro-Electromechanical System (MEMS)

PLL-Based Self-Adaptive Resonance Tuning for a Wireless-Powered Potentiometer

A 26-32Ghz Differential Attenuator with 0.23db RMS Attenuation Error and 11.2dbm IP1dB in 40nm CMOS Process

A 25-35 GHz 5-Bit Digital Attenuator with Low RMS Amplitude Error and Low Phase Variation in 65 Nm CMOS.

Design of a 68 Db Input Dynamic Range Potentiostat for Electrochemical Biosensing