Abstract:A coagulation-microfiltration combination process was used to treat micro-polluted raw water in the intermittent operation mode. The effect of the operational parameters such as filtration time and aeration intensity, on the membrane filtration characteristics was investigated. An indicator J/p, defined as flux per unit pressure, was employed. At all the experimental conditions, J/p always fell down fast at first owing to membrane fouling, and then decreased slowly. But the initial decreasing rate and relative stable value of J/p in the latter period depended on the different operational parameters. J/p was greatly influenced by the filtration time, then the ratio of the filtration time to the ceasing time. Under the condition the filtration time was shortened by 1/2, the flux will increase by two times; when the ratio of filtration time/ceasing time was shortened, the flux was increased by only 50%. Higher J/p value could be achieved at the filtration time of 15 min and the ratio of filtration time/ceasing time of 3.8. Increased aeration intensity could enhance J/p to some extent. In the experiments, when the aeration intensity was increased from 2 to 4 m3/h, the membrane permeability was increased by about 15%; and the membrane permeability would not increased if the aeration intensity was continuously increased to 6 m3/h. Primary inorganic elements on the membrane surface at the present experimental condition were found to be Si and Ca from the element analysis.

Influence of the operation parameters on membrane filtration

Effect of Operational Parameters on Sludge Accumulation on Membrane Surfaces in a Submerged Membrane Bioreactor

Effects of sludge retention time on sludge characteristics in membrane bioreactors

Research on membrane fouling characteristics of the integrated MBR applied to aquacultural wastewater

Influence factors on membrane fouling in a submerged MBR for treatment of high strength organic wastewater

Influences of Sludge Retention Time on Sludge Properties and Membrane Fouling of Submerged Membrane Bioreactor with the Addition of Ca2+

Effect of operational conditions on membrane permeability in a coagulation-microfiltration process for water purification.

Effect of Aeration Intensity on Operating Characteristics of Membrane Bioreactors

Effect of operation conditions on fouling of immersed ultrafiltration membrane for drinking water treatment of surface water

Impacts of sludge retention time on sludge characteristics and membrane fouling in a submerged anaerobic–oxic membrane bioreactor

Operational Stability of Dynamic Membrane Bioreactor and Its Influence Factors

Experimental Research on Mechanism of Membrane Fouling in a Submerged Membrane Bioreactor

Influence of operation conditions on filtration rate in ultrafiltratin system of dyeing and printing wastewater

Microscopic Mechanism Of Membrane Fouling In Micro-Filtration

Study on membrane fouling of submerged membrane bioreactor in treating bathing wastewater.

Study on membrane fouling caused by activated sludge from a membrane bioreactor with long solid retention time

Evaluation of the Importance of Various Operating and Sludge Property Parameters to the Fouling of Membrane Bioreactors.

Impact of short mean cell residence time on biofouling and bacterial community in a membrane bioreactor

[Membrane Fouling Control in a Free-End Comb-Like Hollow Fiber Membrane Bioreactor].

[Membrane Filtration Characteristics and Its Influencing Factors in Coagulation-Microfiltration Combination Process for Water Purification].

Hydrodynamic effect on sludge accumulation over membrane surfaces in a submerged membrane bioreactor