Abstract:The electroplated diamond wire saw has been widely used in the production of semiconductors, photovoltaic devices, etc. Composite electroplating is an important process in the production of electroplated diamond wire saws. The utilization of nickel (Ni)-coated diamonds is a widely adopted approach to enhance the efficiency of the composite electroplating process employed in the manufacturing of wire saws. However, the pristine diamond does not chemically react with Ni, and the interfacial bonding strength between the Ni coating and the diamond is relatively weak. This frequently results in the detachment of diamonds from the Ni coating during the cutting process. To solve this problem, titanium (Ti) -coated diamonds were used in the preparation of wire saws. We had specially developed a vacuum slow evaporation technology to produce diamond micro -powder (8 mu m) with uniform conductive Ti coatings that were firmly bonded with diamond through the interfacial product TiC. A series of electrochemical test results were used to demonstrate the effect of Ti coating on the composite electroplating process. The linear scanning voltammetry curves showed that the addition of Ti -coated diamond shifted the overpotential of composite electroplating in a positive direction, so it promoted the electrodeposition reaction more than diamond powder. The electrochemical impedance spectroscopy revealed that the conductive Ti -coated diamond reduced the charge transfer resistance during composite electroplating. The Ti -coated diamond micro -powder was completely enveloped by an electroplated Ni layer, and TiC formed between the Ti coating and the diamond provided a stronger interfacial bonding force compared to that of the Ni-coated diamond micro -powder. After cutting, the Ti -coated diamond was found not to fall off the wire saw. The use of Ticoated diamond micro -powder as an abrasive will significantly improve the product quality of mass-produced electroplating diamond wire saws.

Composite electroless plating Ni-Ti-Re on surface of diamond

Influence on (Ni-P) Electroless Composite Plating with Carbon Nanotubes

Diamond particles-reinforced Ni-based composite coating on Ti6Al4V alloy: Microstructure, mechanical, dynamic impact and dry-sliding tribological properties

Ti-coated Diamond Micro-Powder for the Manufacture of the Electroplated Diamond Wire Saw

Preparation and tribological properties of novel cold–sprayed Ti–diamond composite coating

Synthesis and properties of electroless Ni–P–Nanometer Diamond composite coatings

The Microstructure and Wear Properties of Diamond Composite Coatings on TC4 Made by Induction Brazing

High Temperature Sliding Wear Behaviors of Ion Plating Tin Composite Coating with Ion Nitriding As Interlayer on Hot Work Die Steel

Wear-resisting Performance of Nano-diamond Powder Composite Plating Layer and its Application

Comparative study on the properties and microscopic mechanism of Ti coating and W coating diamond-copper composites

A novel strategy for improving the wear resistance of electrodeposited Ni-diamond composite coatings by diamond surface morphology modification

Study on the Anti-wear Behavior of Ni-Co/Diamond Nanocomposite Coatings

A Ni/Surface-Modified Diamond Composite Electroplating Coating on Superelastic NiTi Alloy As Potential Dental Bur Design

Studies on Electric Contact Silver Based Composite Deposit Intensified with Nano Crystal Diamond Particles

Production of Cu/Diamond Composite Coatings and Their Selected Properties

Preparation and Characterization of Nanostructured Ni-TiN Composite Films

Effect of Particle Concentration on the Microstructure and Properties of Electrodeposited Nickel–Diamond Composite Coatings

Preparation of Ti-coated Diamond Particles by Microwave Heating

Effect of Ti Microparticles on the Microstructure and Properties of Ni-Ti Composite Coating Prepared by Electrodeposition

Interface Characterization of a Cu–Ti-coated Diamond System

Surface Characteristics and Electrochemical Corrosion Behavior of NiTi Coated with Diamond-Like Carbon