Abstract:The performance of welded Ni-based superalloys at high temperatures is essential to be evaluated due to their particular service environment for aero-engines and high-speed aircrafts. The tensile properties and related microstructural evolutions such as the carbide precipitate and grain of a laser-welded Ni-based alloy were experimentally and numerically investigated at different temperatures (20, 300, 500, 800 °C). The results show that at room temperature, the strength of the Base Material (BM) was slightly smaller, with a difference of less than 1%, than the Welded Material (WM), which can be attributed to the more uniformly distributed needle-shaped carbide precipitates in the WM than those nonuniformly coarser spherical ones in the BM. While at 300 °C and 500 °C, the strength of WM decreased more obviously compared with that of BM due to the more apparent growth of grain: 13.52% loss in yield strength in WM alloys as compared with BM alloys at 300 °C, and 16.57% at 500 °C. At 800 °C, the strength of BM and WM both decreased to a similar level due to Dynamic Recrystallization (DRX). However, a much higher elongation was observed for the BM than WM (less than 50% of BM), which can be attributed to the enhanced dislocation accumulation capability of the large spherical carbides along grain boundaries on the fracture surface in BM. Furthermore, a unified model considering the welding effects on both microstructures (dislocation, carbides, and grain) and mechanical properties evolutions at different temperatures was developed and validated. Based on this model, the key temperature ranges (20–600 °C) where apparent weakening of strength and uniform plasticity occurs for welded structures were identified, providing a direct guidance for potential structure and process design.

Mechanical Behavior of Laboratory Cross-Weld Specimen and its Relation with Practical Cases at Elevated Temperature

DSI-based Studies of the Effects of High-temperature Aging on Local Mechanical Properties of HR3C/T92 Dissimilar Steel Welded Joint

Effect of Welding Defects on Mechanical Properties of Welded Joints Subjected to Temperature

Mechanical properties of butt weldments made with E5515-G electrodes at high temperature

Longitudinal tensile test on weld metal in fusion zone at high temperature

Deterioration of Mechanical Properties of Novel Constructional Steel Material at Elevated Temperatures

Mechanical Properties of Butt Weldments Made with Q345B Steel and E5015 Electrodes at Different Temperatures

High Temperature Mechanical Behavior of 16mnq under Constant Constraint Conditions

Experimental investigation on mechanical behaviours of TMCP high strength steel

Experimental study on fracture toughness of high-strength structural steel and its butt weld

Behavior of High Strength Structural Steel at Elevated Temperatures

Experiments and modeling of microstructural and mechanical behaviors of laser-welded Ni-based superalloy at high temperatures

Thermal Effect of Welding on Mechanical Behavior of High-Strength Steel

Experimental Investigation of Temperature and Contact Pressure Influence on HFI Welded Joint Properties

High-Temperature Mechanical Behavior of an As-Extruded Al-5Zn-2Mg-0.3Cu (in wt.%) Alloy

Experimental study on fracture toughness of high-strength structural steel and its

Microstructure Evolution and Mechanical Properties of TA15/Ti60 Tailor Welded Blank by Electron Beam Welding

Insights into microstructure evolution and fracture mechanisms of welded joints of high strength steel patchwork components

Welding process simulation under varying temperatures and constraints

Micromechanical testing and microstructure analysis of as-welded and post-weld heat-treated Ti-6Al-4V alloy

Experimental Study on Low-Temperature Mechanical Properties of S30408 Welded Joints