Abstract:The 10MW High Temperature Gas Cooled Test Reactor (HTR-10) has been built in Institute of Nuclear and New Energy Technology (INET) and has been operating successfully since the beginning of 2003. The core outlet temperature of HTR-10 is 700℃. To verify the technology of gas-turbine direct cycle, at first INET had a plan to increase its core outlet temperature to 750℃ and use a helium gas turbine instead of the steam generator (then the reactor is called HTR-10GT). Though HTR-10 has good intrinsic safety, the design basic accidents and beyond design basis accidents of HTR-10GT must be analyzed according to China's nuclear regulations due to changed operation parameters. THERMIX code system is used to study the Anticipated Transient Without Scram (ATWS) caused by an earthquake. The gravity acceleration of the earthquake will make the porosity of the pebble bed smaller, which will thus induce a positive reactivity. The packing fraction of the HTR-10GT core will increase to 0.64 from 0.61, while a reactivity of 1.24% will be inserted into a initial core and 0.788% for an equilibrium core. Then the reactor power increased and the temperature of the core increased. When the neutron flux of power measuring range exceeded 123% and the reactor period becomes less than 20 seconds, the reactor should scram. It was supposed that all the control rods in the reflectors had been blocked and the reactor could not scram. Thus the accident went on and the core temperature and the system pressure increased but the reactor shutdown at last because of its natural negative temperature reactivity feedback mechanism. The residual heat would be removed out of the core by the cavity cooling system. During the accident sequence the maximum fuel temperature was 1223℃. If a temperature coefficient error of 20% was considered during analyzing, the peak temperature of the fuel during the ATWS will reach 1266 ℃. It was a little higher than 1230℃--the fuel temperature limitation of HTR-10. Now the sphere fuel used in HTR-10GT will also be used in HTR-PM and the temperature limitation has been raised to 1620℃, so the HTR-10GT is safe during the ATWS caused by an earthquake. The paper also compares the analysis result of HTR10-GT to those of HTR-10. The results shows that the HTR-10GT is still safe during the accident though its operating temperature is higher than HTR-10. The analysis will be helpful to HTR-PM because they have the same outlet temperature of the core.

Analysis of stress in reactor core vessel under effect of pressure lose shock wave

Transient pressure analysis for the reactor core and containment of a HTGR after a primary loop pressure boundary break accident

Study on Pressure Relief Transient for High Temperature Gas Cooled Reactor

Stress Analysis of HTR-10 Steam Generator Heat Exchanging Tubes

Transient Analysis of Active Cooling Procedure of HTR Reactor Core

Analysis on blow-down transient in water ingress accident of high temperature gas-cooled reactor

Safety analysis for hot gas duct vessel in HTR-PM

Analysis of the Structure Stability of the Hot Gas Tube in HTR-PM

Hydraulic pressure test of pressure vessel of 10 MW high temperature gas-cooled reactor

Dynamic Analysis of THRR 20 Internals

Analysis Of Bypass Effect On A 250 Mw High Temperature Gas-Cooled Reactor

Thermal Hydraulic Calculation of the HTR-10 for the Initial and Equilibrium Core

Large Thermal Gradients on Structural Integrity of a Reactor Pressure Vessel Subjected to Pressurized Thermal Shocks

Simulation And Analysis Of Helium Circulator Trip Atws Test At Full Power On The Htr-10

Stress and Seismic Calculation of HTR-10 Primary Loop Pressure Relief System (K417)

Discussion on Amount of Water Ingress Mass in Steam Generator Heat-Exchange Tube Rupture Accident of High-Temperature Gas-Cooled Reactor

Effect of Coolant Water Temperature of Emergency Core Cooling System on Failure Probability of Reactor Pressure Vessel

ICONE19-43309 ANALYSIS ON ATWS CAUSED BY EARTHQUAKE OF THE HTR-10GT

Experimental Study on the Residual Heat Removal System in HTR-10

The ATWS analysis of one control rod withdraw out of the HTR-10GT core in addition with bypass valve failure

Study on pressure relief system design for high temperature gas cooled reactor