Abstract:Increasing demands for high-performance screw pumps in oil and gas as well as other applications require deep understanding of the fluid flow field inside the machine. Important effects on the performance such as dynamic losses, influence of the leakage gaps and presence and extent of cavitation are difficult to observe by experiments. However, it is possible to study such effects using well-validated computational fluid dynamics models. The novel-structured numerical mesh consisting of a single-computational domain for moving screw pump rotors was developed to allow three-dimensional computational fluid dynamics simulation of such machine possible. Based on finite volume method, the instantaneous mass flow rates, rotor torque, local pressure field, velocity field and other performance indicators including the indicated power were predicted. A calculation model for the bearing friction losses was introduced to account for mechanical losses. The geometry of the inlet and outlet passages and piping system are taken into consideration to evaluate their influences on the pressure distribution and shaft power. The paper also shows the influence of rotor clearances on the pump performance. The computational fluid dynamics model was validated by comparing the numerical results with the measured performance obtained in the experimental test rig through the comprehensive experiment performed for a set of discharge pressures and rotational speeds. Validation includes comparison of mass flow rates, shaft power and efficiency under variety of speeds and discharge pressure. It has been found that the predicted results match well with the measurements. The results also showed that the radial clearances have larger influence on the mass flow rate than the interlobe clearance. The correct design of the flow passages within the screw pump plays significant role in minimizing required power consumption. The analysis presented in this paper contributes to better understanding of the working process inside the screw pump and offers a good reference to improve design and optimize such machines in terms of clearance selection, shape of the ports, piping system, etc. In future, this model will be used for analysis of cavitating flows and determining performance of other multiphase screw pumps.

Optimization of Twin Screw Compressor with a Software Package

Research on the Flow Path Design Method of Axial Flow Compressor of Gas Turbine

A throughflow-based optimization method for multi-stage axial compressor

A Mathematical Model Of Movable Component In Single Screw Compressor

Aerodynamic Design Optimization Of The Last Stage Of A Multi-Stage Compressor By Using An Adjoint Method

AERODYNAMICS OPTIMUM DESIGN OF COMPRESSOR BLADES BASED ON NUMERICAL OVERALL PERFORMANCE CALCULATION

Full 3-D Viscous Aerodynamic Optimization Design System for Turbomachinery

The Design of a Twin-screw Compressor Based on a New Rotor Profile

Development of a chamber model considering non-uniform pressure distribution for twin-screw compressors

Aerodynamic Optimization Design for All Condition of Centrifugal Compressor

Optimized Aerodynamic Design of Multi-blade Rows of an Axial Compressor

Design Optimization of the Last Stage of a 4.5-Stage Compressor Using a POD-based Hybrid Model

Review of Design Optimization Methods for Turbomachinery Aerodynamics

Multi-objective Optimization Design of Axial Compressor Blade and Stability Margin Analysis

Research on Optimization of Profile Parameters in Screw Compressor Based on BP Neural Network and Genetic Algorithm

Numerical modelling of twin-screw pumps based on computational fluid dynamics

Simulation of High Speed Oil-free Twin-screw Compressor in Fuel Cell

AERODYNAMICS OPTIMUM DESIGN OF BLADES IN CENTRIFUGAL COMPRESSOR

Optimal Design and Analysis of a High-Load Supersonic Compressor Based on a Surrogate Model

Advanced Aerodynamic Optimization System for Turbomachinery

Design Optimization of a High-Speed Twin-Stage Compressor for Next-Gen Aircraft Environmental Control System