Abstract:An aerodynamic optimization design process of multistage axial turbine is presented in this article: first, applying quasi-three dimensional (Q3D) design methods to conduct preliminary design and then adopting modern optimization design methods to implement multistage local optimization. Quasi-three dimensional (Q3D) design methods, which mainly refer to S2 flow surface direct problem calculation, adopt the S2 flow surface direct problem calculation program of Harbin Institute of Technology. Multistage local optimization adopts the software of Numeca/Design3D, which jointly adopts genetic algorithm and artificial neural network. The major principle of the methodology is that the successive design evaluation is performed by using an artificial neural network instead of a flow solver and the genetic algorithms may be used in an efficient way. Flow computation applies three-dimensional viscosity Navier?Stokes (N-S) equation solver. Such optimization process has three features: (ⅰ) local optimization based on aerodynamic performance of every cascade; (ⅱ) several times of optimizations being performed to every cascade; and (ⅲ) alternate use of coarse grid and fine grid. Such process was applied to optimize a three-stage axial turbine. During the optimization, blade shape and meridional channel were respectively optimized. Through optimization, the total efficiency increased 1.3% and total power increased 2.4% while total flow rate only slightly changed. Therefore, the total performance was improved and the design objective was achieved. The preliminary design makes use of quasi-three dimensional (Q3D) design methods to achieve most reasonable parameter distribution so as to preliminarily enhance total performance. Then total performance will be further improved by adopting multistage local optimization design. Thus the design objective will be successfully achieved without huge expenditure of manpower and calculation time. Therefore, such optimization design process may be efficiently applied to the aerodynamic design optimization of multistage axial turbine.

Review of Design Optimization Methods for Turbomachinery Aerodynamics

Performance Sensitivity Analysis and Aerodynamic Optimization of Compressor Cascades by a Turbulence Adjoint Method

A Gradient-Based Method Assisted by Surrogate Model for Robust Optimization of Turbomachinery Blades

Flow Reconstructions and Aerodynamic Shape Optimization of Turbomachinery Blades by POD-based Hybrid Models

Performance Improvement of Optimization Solutions by POD-based Data Mining

A throughflow-based optimization method for multi-stage axial compressor

Assessment of Turbulence Adjoint Method in Sensitivity Calculation and Aerodynamic Design Optimization of Turbomachinery Cascades

Optimization Design of a Turbine Blade to Reduce Secondary Flow Loss Using a Viscous Adjoint Method

Aerodynamic Design Optimization Of The Last Stage Of A Multi-Stage Compressor By Using An Adjoint Method

Optimization Design of Aspect Ratio and Solidity of a Heavy-Duty Gas Turbine Transonic Compressor Rotor

Design Optimization of the Last Stage of a 4.5-Stage Compressor Using a POD-based Hybrid Model

Study on Aerodynamic Optimization Design Process of Multistage Axial Turbine

Advanced Aerodynamic Optimization System for Turbomachinery

Retrospect and Prospect for Adjoint Method Applying to Turbomachiney Optimization Design

Optimal Design and Analysis of a High-Load Supersonic Compressor Based on a Surrogate Model

Full 3-D Viscous Aerodynamic Optimization Design System for Turbomachinery

Aerodynamic Optimization Design for All Condition of Centrifugal Compressor

A cooled turbine blade design and optimization method considering the cooling structure influence

A Dimension Reduction-Based Multidisciplinary Design Optimization Method for High Pressure Turbine Blades

AERODYNAMICS OPTIMUM DESIGN OF BLADES IN CENTRIFUGAL COMPRESSOR

Multi-objective Optimization Design of Axial Compressor Blade and Stability Margin Analysis