Abstract:The frequency bandwidth of photothermal technique for thermal conductivity depth profiling has been studied, which is based on an iterative numerical algorithm for inverse calculation of inhomogeneous thermal conductivity depth profiles of solid samples. This inversion algorithm should require a sufficient frequency bandwidth since the numerical experiments have demonstrated that systematic errors will occur in the inversion from insufficient data. According to the thermal wave propagation property, at low frequency range, the thermal wave can penetrate into deep region of the sample, but it will depress spatial resolution because of its long thermal wavelength. Nevertheless, lack of low frequency the detected information will cause the derivation of the depth profiling in the deep part. On the other hand, with high frequency, the thermal wave only can penetrate into shallow regions near the surface of the sample, although the spatial resolution will be intensified because of its short thermal wavelength. However, lack of high frequency information will induce the depth profiling derivation near the surface layer. Theoretical analyses have indicated that there is a high frequency fhigh, at which or over the amplitude of the surface temperature tends to be proportional inversely to square root of frequency f, but the phase tends to a constant 0.25π. Besides, there is a low frequency flow, at which or below the amplitude will tend to be inversely proportional to f and the phase will tend to a constant 0.5π under the heat-insulation boundary condition at the rear surface. With the frequency bandwidth (flow,fhigh) all the necessary information is essentially included for reconstructing the depth profiling. Practically, the numerical experiments have also demonstrated the frequency bandwidth can be less than (flow,fhigh) based on the investigated conditions, which will be described in detail in the paper.

A New Method of Reconstruction of Thermal Conductivity-Depth Profiles from Photoacoustic or Photothermal Measurements

Depth Profile Reconstruction of the Thermal Conductivity of Inhomogeneous Solids: Application to Laser-Hardened Al Alloys

Reconstruction Theory of Thermal Conductivity Depth Profiles by the Modulated Photoreflectance Technique

Depth Profiling of Thermal Relaxation Time and Thermal Conductivity Related to Hyperbolic Heating Propagation

Photothermal Inversion of Thermal Parameters Related to Hyperbolic Heating Propagation

Thermal Depth Profiling Reconstruction by Multilayer Thermal Quadrupole Modeling and Particle Swarm Optimization

Regularized algorithm for inverse problem in photothermal detection

Depth Profile Reconstruction of Thermal Relaxation Time

construction of thermal conductivity distribution of inhomogeneous solids:laser-hardened Al alloys studied by photoacoustic technique

Two-dimensional Reconstruction Theory of Thermal Conductivity Profiles Based on the Thermal Wave Technique

Simultaneous Reconstruction of Multiple Time-Varying Thermal Properties Based on Translucent Materials

Machine learning reconstruction of depth-dependent thermal conductivity profile from pump-probe thermoreflectance signals

Frequency Bandwidth Optimization Of Photothermal Technique For Thermal Conductivity Depth Profiling

Photothermal testing of composite materials: Virtual wave concept with prior information for parameter estimation and image reconstruction

The Reconstruction of the Space-Dependent Thermal Conductivity from Sparse Temperature Measurements

Numerical and Experimental Investigations on the Total-Variation Regularization Method of Temperature Distribution Reconstruction in Acoustic Tomography

Estimation of linear expansion coefficient and thermal diffusivity by photoacoustic numerical self-consistent procedure

Photo-Acoustic Measurement of Thermal Conductivity of Thin Films and Bulk Materials

A Numerical Algorithm for Inverse Problems in Photothermal Detection

A New Noncontact Probe for Thermophysical Properties of Solid Surfaces

Acoustic Tomography of Temperature Field by Finite Element Method and Improved Singular Value Decomposition-Based Tikhonov Regularization