ISIJ International, Vol. 46 (2006), No. 4, pp. 546–552
Yin HEBI,Yao MAN,Zhan HUIYING,Fang DACHENG
2006-01-01
Abstract:Many mathematical models describing the thermo-mechanical behaviors of strand and mould have been documented and used in recent years to make a further understand on the deformation behaviors of the solidifying shell and mould distortion. In the earlier stage, many two-dimensional thermo-mechanical mathematical models, either in transverse section or in axial planes, had been developed to predict the stress generation. And Thomas et al. developed a two-dimensional slice stress model at the height corresponding to the highest mould temperature from a three-dimensional heat transfer model for slab casting. And even three-dimensional thermo-mechanical models have also been developed, at the expense of greater computation time and memory. In the casting process, the heat transfer from the billet to mould and the deformation of mould interact each other. So, many models were developed for the coupled analysis of them of both billets and slabs. Kelly developed a model coupling the mould heat transfer and mould deformation by direct computation of the gap thickness, and by cycling between the thermal and stress analysis to derive a self-consistent solution for the temperature distributions in and of mould, along with the air gap size. To make the results better reflect the real casting conditions, the stress states of strand and mould was predicted based on the calculation temperature as thermal load by inverse model from thermocouples reading along the centerline for slab and billet casting. During the continuous casting mould process the solidifying shell is subjected to various stresses, including thermal stress, stress due to ferrostatic pressure, and stress caused by friction (liquid lubrication and solid–solid contact friction), and even their combined stress. Ferrostatic pressure in the calculation of strand stress had been considered by most of the thermo-mechanical models mentioned above. The mould can interact mechanically with the shell if contact occurs, and so contact and friction against the mould is the source of many of the critical stresses in a casting, and one 2D model investigated the effect of contact friction between solidifying shell surface and mould wall based on the Coulomb friction law. The real continuous casting mould process in plant is still not fully understood. In the present work, an attempt is made to improve this situation by developing an appropriate three-dimensional, thermo-elasto-plastic finite element stress model taken the temperature of strand and mould as thermal loaded, calculated by the 3D inverse problem model from the measured temperatures by the thermocouples buried in various locations, in so doing, a fresh insight has been gained into the thermal-mechanical states of strand and mould. Furthermore, the influence of mould friction on strand stress is also discussed.