Abstract:A model for variable pressure infiltration of fibrous preforms by molten metal has been developed. The mechanism of the infiltration and the effects of fiber distribution and wettability on infiltration resistance and composite microstructure have been studied. It is shown that the model is in good agreement with the experimental data on infiltration of carbon-fiber preforms by Al-Si eutectic. The solution of the resulting equation shows that the rate of infiltration is only a function of the rate of change of pressure Ф, by which the infiltration processing is controlled precisely. Two kinds of infiltration modes have been found. A critical fiber volume fractionVc exists, which is the turning point of the infiltration modes as well as permeability. As fiber volume fraction exceedsVc, the infiltration mode changes from nonuniform to uniform, resulting in a sharp decrease in permeability. The permeability and resistances of these two infiltration modes are well predicted by the variable pressure infiltration theory. If fibers are wetted by molten metal, the preforms can be completely infiltrated at low applied pressure. In the case of nonwetting, poor infiltration of the preforms up toVcresults, though high pressure is applied, but quality composites are formed at a low applied pressure if the fibers in the bundles are fixed relative to each other. A novel process, variable pressure infiltration technique, has been generated, which offers the advantages of low applied pressure, easy control of the pro-cessing, and no requirement of wetting. Quality C/A356 composites have been fabricated by this technique with the investment precision casting molds at a pressure of 0.6 MPa. Also, the mechanical properties of the composites are studied. The composites have high strength with a special fracture mechanism.

FABRICATING STEEL-BASED COMPOSITES CONTAINING CERAMIC PARTICLES WITH VACUUM INFILTRATION PROCESS

Fabrication of fiber-reinforced metal-matrix composites by variable pressure infiltration

Influence of Fabrication Process on Magnetic Properties of Co-Finemet Nanocrystalline Powder Core

PREPARATION OF TiC/SiC AND TiN/SiC COMPOSITE CERAMICS FROM LIQUID SILICON INFILTRATION

A Novel Approach to Fabricate Ceramic/metal Interpenetrating Phase Composites by Ultrasonic-Assisted Spontaneous Infiltration

Fabrication and Microstructure of C/Cu Composites

The fabrication of composites with interpenetrating networks based on woodceramics

Recent Developments in Fabrication of Ceramic Particle Reinforced Iron Matrix Wear Resistant Surface Composite Using Infiltration Casting Technology

Fabrication and interface property of WC-TiC-Co/Cr20 composites

Preparation and Interface Structure of CTCp/Cr26 Composites with the Pinning Effect

Study of Rapid Fabrication and Microstructure of C/C-SiC Composites

Liquid infiltration and filling process for fiber reinforced metal matrix composites

Fabrication of 3D-SiC/aluminum alloy interpenetrating composites by DIW and pressureless infiltration

Dissolution Behavior of WC Particle in WC Steel Matrix Composites by Electroslag Melting and Casting Method

Fabrication of WC Particles Reinforced Iron Matrix Surface Composites by Centrifugal Casting

Fabrication of Co-Continuous SiC/Al Composites from Novel SiC Preforms with High Porosity and Controllable Pore Size

Improvement of Film Boiling Chemical Vapor Infiltration Process for Fabrication of Large Size C/C Composite

Improvement of Chemical Liquid Vaporized Infiltration Process for Fast Densification of Carbon/Carbon Composites

Processing of ZrC-W composites produced by reactive melt infiltration method

Fabrication of Ni/WC composite with two distinct layers through centrifugal infiltration combined with a thermite reaction

Study on WC Particles Reinforced Steel Matrix Revolving Parts Prepared by Centrifugal Casting