Abstract:We measured various operational parameters of a 200-MWe, wall-fired, lignite utility boiler under different loads. The parameters measured were gas temperature, gas species concentration, char burnout, component release rates (C, H and N), furnace temperature, heat flux, and boiler efficiency. Cold air experiments of a single burner were conducted in the laboratory. A double swirl flow pulverized-coal burner has two ring recirculation zones that start in the secondary air region of the burner. With increasing secondary air flow, the air flow axial velocity increases, the maximum values for the radial velocity, tangential velocity, and turbulence intensity all increase, and there are slight increases in the air flow swirl intensity and the recirculation zone size. With increasing load gas, the temperature and CO concentration in the central region of burner decrease, while O2 concentration, NOx concentration, char burnout, and component release rates of C, H, and N increase. Pulverized-coal ignites farther into the burner, in the secondary air region. Gas temperature, O2 concentration, NOx concentration, char burnout and component release rates of C, H, and N all increase. Furthermore, CO concentration varies slightly and pulverized-coal ignites closer. In the side wall region, gas temperature, O2 concentration, and NOx concentration all increase, but CO concentration varies only slightly. In the bottom row burner region the furnace temperature and heat flux increase appreciably, but the increase become more obvious in the middle and top row burner regions and in the burnout region. Compared with a 120-MWe load, the mean NOx emission at the air preheater exits for 190-MWe load increases from 589.5mg/m3 (O2=6%) to 794.6mg/m3 (O2=6%), and the boiler efficiency increases from 90.73% to 92.45%.

Experimental Research On The Spectrum Properties Of Combustion Noise In Coal-Fired Boilers

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Experimental Study on the Dynamic Property of Radiation Signals' Spectrum Distribution Within Pulverized Coal Boilers

An Experimental Research on Boiler Combustion Performance

EXPERIMENTAL STUDY ON THE PROPERTY OF Nox EMISSION IN HIGH TEMPERATURE COMBUSTION OF COMMONLY USED COAL SORTS AND THEIR MIXTURES IN LARGE-SCALE TANGENTIALLY FIRING PULVERIZED COAL BOILERS

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

The investigation and measurement on the pulverized coal combustion in tangentially-fired boiler

Experimental research on visualization of Nox emission with 3-D temperature distribution in a boiler

The Experimental Study of Combustion Control Based on Furnace Radiant Energy Signa in Once-through Boiler

Measurement method and experimental research on flame emissivity in coal-fired furnaces

Characteristics of Combustion and NOx Emission in a 600 MWe Wall-Fired Boiler Under Varying Coal Mill and Burner Damper Configurations

Visualization Detections Of The Combustion In A 300-Mw Arch-Fired Boiler

Experimental Research on the Combustion and NO_x Generation Characteristics of Low Volatile Coal

B217 VISUALIZATION DETECTIONS OF THE COMBUSTION IN A 300-MW ARCH-FIRED BOILER(Combustion-8)

Combustion Stability, Burnout and NOx Emissions of the 300-MW Down-Fired Boiler with Bituminous Coal: Load Variation and Low-Load Comparison with Anthracite

E306 EXPERIMENTAL STUDY ON PERFORMANCE OF COMBUSTION AND NO EMISSION FOR LOW VOLATILIZATION COALS

Experimental Research on NOx Emission Characteristics During Coal Combustion in the Stoker-fired Boiler

Numerical Simulation of Combustion Characteristics and Nox Emissions in A 300 Mwe Utility Boiler with Different Outer Secondary-Air Vane Angles

Experimental and Numerical Investigation of Combustion System Improvement on 600MW Bituminous Coal Boiler for Burning Lignite Coal

Measurement of Gas Species, Temperatures, Char Burnout, and Wall Heat Fluxes in a 200-Mwe Lignite-Fired Boiler at Different Loads

Research on combustion visualization of coal-fired boilers based on thermal imaging technology