Abstract:The ultrahigh static displacement-acceleration sensitivity of a mechanical sensing chip is essential primarily for an ultra-sensitive accelerometer. In this paper, an optimal design to implement to a single-axis MOEMS accelerometer consisting of a grating interferometry cavity and a micromachined sensing chip is presented. The micromachined sensing chip is composed of a proof mass along with its mechanical cantilever suspension and substrate. The dimensional parameters of the sensing chip, including the length, width, thickness and position of the cantilevers are evaluated and optimized both analytically and by finite-element-method (FEM) simulation to yield an unprecedented acceleration-displacement sensitivity. Compared with one of the most sensitive single-axis MOEMS accelerometers reported in the literature, the optimal mechanical design can yield a profound sensitivity improvement with an equal footprint area, specifically, 200% improvement in displacement-acceleration sensitivity with moderate resonant frequency and dynamic range. The modified design was microfabricated, packaged with the grating interferometry cavity and tested. The experimental results demonstrate that the MOEMS accelerometer with modified design can achieve the acceleration-displacement sensitivity of about 150 mu m/g and acceleration sensitivity of greater than 1500V/g, which validates the effectiveness of the optimal design.

Design and Fabrication for Inertial Micro Sensors

Design of Infrared Static Focal Plane Earth Sensor for Micro-Satellite

Micromachined Fluid Inertial Sensors

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Optical Design and Analysis of a High Resolution MOEMS Accelerometer Based on Diffraction Grating

Application of MEMS in Inertial Measurement

Inertia measure using MEMS gyroscope

Status and development trend of MEMS inertial sensors

One Single Chip Micro Inertial Measurement Unit

Design and calibration of MIMU based on chip size micro inertial sensors

Designing Gram-Scale Resonators for Precision Inertial Sensors

Micro Inertial Measurement System

Design of Micro Inertial Measurement Unit Based on Micromachined Thermal Expansion Gas Gyroscope

Modeling And Experimental Study On Characterization Of Micromachined Thermal Gas Inertial Sensors

A Review on the Inertial Measurement Unit Array of Microelectromechanical Systems

Materials Selection In Mechanical Design For Microsensors And Microactuators

Design and Fabrication of an Electrostatically Suspended Micromachined Gyroscope

Research on the Calibration Method of Micro Inertial Measurement Unit for Engineering Application.

Micromachined Gas Inertial Sensor Based on Convection Heat Transfer