Abstract:Soaking time and loading rate are the two important process parameters for semi-solid powder forming, which are next only to powder temperature. However, there have been few investigations on the influence of soaking time and loading rate on the semi-solid compression of porous material, which is an effective method for studying the deformation characteristics of semi-solid materials and is widely used to optimize the semi-solid forming processes. Therefore, the microstructures, grain size and shape factor, liquid fraction, relative densities and stress–strain curves of Al-4Cu-Mg alloy with a porosity of 30% compacted at different soaking time and loading rates were measured, and the strain rate sensitivity coefficient, the relationship between peak stresses and strain rates, and the processing map were calculated and analyzed. The results indicate that as the soaking time increases, the particle grows and the liquid fraction increases slightly, and the liquid distribution changes from dots in grains to concentrating on grain boundaries in powders, making the relative density increase basically and the peak stress decrease firstly and then increase slowly. Thus, the most suitable soaking time for semi-solid compression is 2 to 5 min. With the loading rate increasing, the particle size reduces first and then increases, the relative density decreases, while the peak stress basically raises, combining the action of powder breakage, grain coarsening and liquid flowing. The peak stress basically has a power relationship with the strain rate, and the processing map can be used to analyze porous semi-solid materials, which are verified to be consistent with the experimental results. Therefore, the optimal semi-solid forming parameters of Al-4Cu-Mg alloy powders are at a deformation rate ranging from 0.6 to 6 mm/s and at a temperature of 860 to 873 K.

Study of fabricating technology of a porous aluminum alloy

Fabricating of Open-Cell Porous Al-Si Alloy with Pressure Penetration Casting

Fabrication of Nanocrystalline Zro2 Particle Reinforced Aluminum Alloy Composite by Squeeze Casting Route

Preparation, Characterization and Designing of Porous Ti–6Al–4V Through Metal Injection Molding Without Space Holder

Uncovering the effects of local pressure and cooling rates on porosity formation in AA2060 Al-Li Alloy

FABRICATION OF ALUMINUM-SALT COMPOSITE AND ITS THERMAL EXPANSION PROPERTY

Study of Fabrication on Sponge Aluminum by Investment Casting

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Effects of Process Parameters on Internal Quality of Castings During Novel Casting

Statistical Investigations of Serpentine Channel Pouring Process Parameters on Semi-Solid ZL101 Aluminum Alloy Slurry Using Response Surface Methodology

Preliminary development of porous aluminum via powder metallurgy technique

Processing Parameters of LFC Shell Mold Casting Aluminum Alloy Castings with Vacuum and Low Pressure

Experiment on Microporosity in Squeezing Casting Aluminum Alloy Parts

Quantifying the effects of cooling rates and alloying additions on the microporosity formation in Al alloys

Enhancing Capillary Pressure of Porous Aluminum Wicks by Controlling Bi-Porous Structure Using Different-Sized NaCl Space Holders

FABRICATING POROUS ALUMINIUM WITH DIRECTIONAL SOLIDIFICATION OF Al-H SYSTEM

Effects of cooling rates on microporosity in DC casting Al-Li alloy

Fracture Behavior of a High Pressure Die Casting AlSi10MnMg Alloy with Varied Porosity Levels

Influence of Soaking Time and Loading Rate on Semi-solid Compression of Porous Al-4Cu-Mg Alloy

Fabrication of Porous Alumina Ceramics with Directional Pore Channels Structure by Freeze-Gel Casting Processing

Manufacturing Processes of Porous Metals